💡 Light Up Your Security Game!
The AuraglowPIR Motion Sensor Double Up & Down Outdoor Wall Security Light combines style and functionality, featuring a PIR motion sensor that activates in darkness, an override function for manual use, and robust weather resistance. With a powerful 1100 lumens output and a wide 180-degree detection angle, this light is designed to enhance your home security while looking sleek and modern.
M**R
Great set of lights that work perfectly
The only issue I have, is that wires need to be fed through from the back of the light, so please consider how to feed wires from where light is being installed. I had to make a wooden block so I could feed wires through the block and into the light
M**E
Nice addition
Used this for our cabin in the garden. Looks nice and modern and has a nice reflective light. Easy to fit. As per reviews unable to change length of time sensor stays on but not too much of an issue for us
J**N
Good light, looks good
Really happy, just what we wanted outside our front door
P**S
Good but not quite perfect
Likes: well made, can be used in PIR motion detection mode or in dusk-to-dawn mode. Dislike: cable inlet is in the back and made for fitting over where the cable comes through the wall - I had to use rubber spacers to space the light away from the wall in order to be able to get the cable to the inlet. Also the cable inlet grommet seems a bit flimsy. That said the unit is well made with a die cast metal body, not plastic as with most lights. It should last well. Time will tell. I have given four stars but would have given five if not for the cable fitting issue making fitting tricky (not for the faint hearted!).
R**S
Brilliant purcyase
Great designGood all round lighting effect
S**N
Great purchase .
Great quality and so stylish light.emits a good amount of warm light.also it creates shadows on the wallVery modern .really pleased
P**I
Pir
Very stylish easy to fit and set up
G**D
Poor Design
Not yet put up:The back (to put on the wall) is released by undoing screws top and bottom, which do not screw into anything, but merely go behind the plate material and hold by the pressure of the screw. Take of the back and it has an earth wire fixed to it from inside the light, so you have to take this off first to mark the holes for using the backplate for marking hole position for drilling and then fixing the lamp to it (RE-ATTACHING THE EARTH WIRE FIRST!). Attaching the lamp to the backplate is a little tedious as there is so much inside the lamp that it is awkward to get it positioned to enable the screws to be done up.To adjust the brightness and timing of light you, effectively, have to take it off the wall. The 'adjusters' are inside the casing and on some piece of plastic where the markings are barely visible.Next we come to the fitting of light bulbs, which were supplied loose. Undo screws to top and bottom of the lamp to do this, but it is not screws, but a Torx ( star) screwdriver! Another tedious job to insert by the look of it.I am looking at returning these lights
Trustpilot
1 week ago
4 days ago