5PCS ACF Release Film for Mars 4 Ultra 3D Printer

I got caught by the videos that nFEP was better and replaced one of my VATs with nFEP. That was a nightmare in separating the layers of the nFEP and putting it on the VAT. Elegoo has it right. The ACF is clearly labeled with an easy to use removable center section that contains instructions. Took me seconds to remove the film and put the vat back together. The nFEP was more finicky and if it really did provide superior prints over ACF that was lost in the higher rate of support failures. My MARS 4 ULTRA came with ACF and that is the easier solution for me. I don’t have to fiddle with different settings for small, medium, and large prints. The ACF works well with a single dialed in setting.

funcionan como indica el fabricante, elegoo nunca decepciona

Finally swapped out mine and was really easy to replace.

Fast shipper and worked awesome got the 3d printer back up and printing. Easy to install remember peel slowly and evenly. If any restriction lower back and restart the peel.

Quality films. They produce the best prints.