Red Light SPST 3-Pin ON/Off Round Boat Rocker Switch AC 6A 250V 10A 125V 5 Pcs

I used these switches to build a 110V power strip for the additional A/V devices on my desk. The Left switch is a master switch and is wired to an outlet that a small TV is plugged into, the second controls a cable box, the 3rd is for a ROKU and the right most is for a DVD player. This way, I avoid "ghost currents" for devices I am not using at any given time. Also, turning off the master cuts the power for all of the devices. The fact that they are lighted is a good visual to what has power at any given time.

is very fragile. Used in my cofee machine

I found these on Amazon and thought they would work for my Mickey Mouse waffle maker, as the on/off switch was broken. Sure enough the switches fit the base of the unit and worked like a charm. This was much better than purchasing a new Mickey Mouse waffle maker. I would definitely recommend these if your switch is similar.

They work as promised however after a while the light does go out so if you don’t care about the light there’s no problem

Replacement switch on dryer motor blower, identical to one that's on blower. works like new again.

Replaced broken power switch in a Cabelas dehydrator. Worked fine for a week, then light began to dim and the mechanical part of the switch failed. Replaced the switch again with another from this package. Still working after 3 days - will update review after a month of it working.

Product was awesome but they were the wrong size for my fireplace

As others have shown, this switch is a drop-in replacement on certain Mr. Coffee models. Unplug pot. Remove a handful of screws from bottom to expose the failed switch. Squeeze the tabs holding the switch in place and remove it from the housing. One-at-a-time, remove the three wires by lifting the tab on each lug connector (fingernail will do it). Making sure the wires pass through the housing to the replacement switch, "click" them in place. We do this one-at-a-time to ensure the wires end up on the same terminal of the replacement switch. Then, snap the replacement switch back into the housing, re-install the half-dozen or so screws, plug pot in, toggle switch to the ON position, observe it lights. Check for warmth on the burner - will heat up rapidly so don't hold your hand on it after you start to feel warmth.

コーヒーメーカーのスイッチが壊れたので取り替えました。 大きさも規格もピッタリで買い替えずに済み助かりました。 数は10個もいらないのですが安く手にはいり、ありがとうございました。

Worked well just had to use a Multimeter to identify the pin outs. Two silver spade terminals and one copper colored. The two silver are the switch and the copper is the internal light

コーヒーメーカーの修理用として、購入しました。 ヒーターの容量を満足する接点容量が、あり満足いています。

works as replacement for Bunn coffeepot switch

到着後、念のために通電チェックしたところ、スイッチのセットが逆向きなものが1/10であったので返品しました。見栄えは良かったので残念でしたが。