KEMIMOTO UTV Windshield Wiper Kit Hand Operated Manual Windshield Wiper for Hard Coated Or Glass Windshields Compatible with Maverick X3 Commander Defender Pro Golf Cart

I bought this for my 2018 Polaris Ranger with a hard coated poly windshield. It was hard to see out the the windshield when it rained. The wiper kit is a a great value for the money. It was easy to install and after a little tweaking it works great. It applies good pressure to the windshield and wipes cleans. Double check your measurements before drilling the hole.......you only get one chance to make it right. Looks great after installation. Coverage for the wiper is way better than I expected.

Easy-to-use, works fine

perfect for what i needed

Perfect product for what I needed

Put this on the rear window of my tractor. Had to replace the wiper blade after the original broke during installation. Bad plastic! The wiper arm is questionable but it works. Would pay twice this amount for a higher quality unit.

This was a lifesaver on a recent ride up in the mountains where it was raining pretty hard. It was so nice to not have to get out and manually clean things off during the actual ride. I have a Can Am Maverick X3 with a Bent Metal windshield and it works great on that bigger glass windshield. Popped out the plastic plug in the pre-drilled hole and had this installed in less than 5 minutes!

I have bought two Kemimoto products now that are way off from the advertised measurements. First was the front bumper bar for a can am x3 which set the mounting holes at least 1/2 inch off from the bolt position now this product. Measurement in the ad said the J hook arm is 13 inches but I guess my three tape measures are off as this comes in at 11 on all three. Sadly those 2 inches make up a lot of difference in the sweep and do not clean in front of my drivers view. Also the plastic bits on it are so cheap it broke when attempting to take the wiper blade off i doubt i can return this product or get a refund now.

Installed on UTV polycarbonate windshield, which allegedly has a special coating so hopefully will be scratch resistant. Bought this windshield wiper for those rare instances when it's really needed, not for frequent use. The install was straightfoward, but the spring which presses the wiper arm to the windshieldwas very stiff and strong so turning the handle to operate the windshield requires significant force, don't know of a way to adjust the pressure of the wiper blade against the windshield. Also, the handle rod end has small gear-like teeth that set into the base of the wiper arm to give it grip to turn. I don't know how long this will last or might strip, as the teeth are very small so I wouldn't expect that after a few slips those teeth would wear down and the entire unit inoperable. That to me is a poor engineering design, relying on several teeny gear teeth to grip and turn the blade and last for a long time. Also, the rod fits through a sleeve in which the windshield hole has been drilled, there is nothing that maintains/holds the rod in place at a set distance / measure in the sleeve. The rod easily pushes in and out about an inch or so, which again, makes it seem over long use having so much variable movement that something will slip, damage, strip. Time will tell if this wiper assembly will last.