WeatherTech Custom BumperTopper for Honda Pilot, Rear Bumper Protector (BP0070), Black

Perfect! Easy to put on and just what the Honda trail sport pilot needed!!

This item was very easy to install and the kit came with everything needed. As others have said I would like it to have been about 6 inches longer.

Fit like a glove and looks like original equipment. The installation tape is a bit tricky but just take your time. It protects the deck nicely. I have tested it by loading some doors in my Pilot. The protection took the hit instead of the paint job. It’s a bit pricey but the fit is perfect and the look is fantastic. Plus, it’s American made which is a nice plus. You get what you pay for. Follow the instructions to the letter!

Excellent product good quality looks amazing and better protection then other brands. Thanks WT.

This fits well but is a little expensive for what it is. Adhesion seems very good and it seems like it will provide good protection. But an important not on that: when you first set it, I recommend that you pull a little more of the backing than what they say and then don't press hard until all the backing is removed. For me, the backing tape broke as I was pulling it off, and I almost could not pull the rest of it off because I had pressed half of it and it was pretty tight. But there was just enough backing tape still sticking out such that I could grab it with needle nose pliers and carefully get the rest of the backing off.

Work wonderful and it does protects

I have purchased many WeatherTech products in the past. This is the first time I was disappointed with the quality of a product. While the installation went well with good fit, alignment and adhesion; after it was installed I noticed light grey/blackish streaks and marks throughout the entire molded part. The marks were worse at the middle and ends. I was expecting a completely black product, not one that appears to have multiple molding colorant defects in it. They are NOT stress marks. At this point it is installed, and removing it is not a good option without destroying it or damaging my Pilot bumper. And I doubt WeatherTech will step up and admit their product is defective and replace it with a properly molded part. It is unfortunate, because I actually like how the product fits well and would look great otherwise. I guess everyone will look at the defects and see the WeatherTech logo prominately stamped into the right end for good advertising. Don't know how this got through manufacturing quality control (US Made Product). Will make me think twice about ordering WeatherTech in the future.

Fits perfectly and really like the way it came packaged, this is exactly what people expect with all there purchases, on time also , thank you ,

After reading a few of the reviews, I have concluded that people don’t read the instructions properly!! The weather tech bumper protector fits perfect. But again, I did exactly what they said. The only thing I added, was that it was colder than the 16*C they recommended, so I used a heat gun to warm the surface of the bumper and the protector. It stuck perfectly, no lifting on the corners, etc,etc🤣. This piece is as close to factory as you can get.

It was good & looks nice in the car

2025 Honda pilot trailsport. Lifting on both ends. Worried it might fall off the vehicle while driving.

Overpriced for the size of plastic you receive. Similar to others fit is not perfect, had to use heat gun to get to match bumper because lifting on one side.