BSI 142 Foam Cure 4 oz

Foam Cure is a winner! Works on virtually any foam (Styrofoam, EPO, EPS, EPP, Depron, etc.). Bob Smith adhesives are first-rate and this slightly flexible Foam Cure adhesive works better than many other popular brands I have tried.For years, I have used Foam Cure primarily for building foam radio-controlled model airplanes. There are many types of glues commonly used on these foamies (epoxy, instant CA glues, Gorilla Glue, white glues, & others). There is also considerable debate over which foam adhesive works best. However, in my considerable experience (former engineer in the RC industry), none work better overall than Foam Cure.Nearly all foam materials are sensitive to the solvents often found in common adhesives (can dissolve the foam material). Also, typical instant CA glues (cyanoacrylate adhesives) generate considerable heat while curing. This catalytic reaction melts the foam, weakens the joint and it fails. This problem increases when CA accelerators are used. Therefore, special foam-safe CA adhesives & accelerators are required to avoid this problem. In contrast, Foam Cure chemistry is formulated specifically for foam and can be successfully used on virtually all common foam materials.Bob Smith Foam Cure is reasonably priced, the larger bottle & applicator tip are easy to use, and the adhesive has a long shelf-life if the bottle is properly capped. For best adhesion and faster curing, use Foam Cure like contact cement. Spread thinly and evenly on both surfaces, briefly join and pull apart for about 5 minutes and then rejoin.If an instant bond is required, parts can be held in place by applying a few additional spots of foam-safe instant CA glue. Foam Cure requires 12 hours to fully cure. It dries clear and remains slightly flexible for years. Check out this terrific adhesive for yourself. I'd bet using Foam Cure will put a smile on your face too.

This is a great product, just tried it on the assembly of a plane, worked really great! Will definitely buy again!

Excellent foam safe adhesive. Works well in UMX rc planes

Product works as expected. Good price. Fast shipping.

If you want to bond multiple layers of pick and pull foam for your valuable video or musical instruments in a custom case... This is the stuff to use. It's very easy to use. Just allow at least 24 hours to fully bond and you are good to go.Side note: After you bond the layers together, follow up by coating the pick and pull foam with multiple coats of Plast-Dip and your case will last a long time.