Rear Window Interior Shelf Storage Molle Panel Fit for Ford Bronco (Hard Top) 4 Door 2021 2022 2023 2024

Got the panels, installed the driver's side in about 40 minutes. No drilling or modifications to the car needed. The instructions are good, cryptic, you have to pay special attention to the parts, but once you figure it out, it goes pretty well.Two modifications.The "panels" you remove to mount the top bracket to the side of the car - the instructions do not tell you to put it back, but you can and it fits fine.When you install the "feet" where the cargo tie downs are, it has you put the brackets on top of the tie downs. When I did, the cargo loop would not lay flat. I changed it an put the tie downs on top, everything installed just fine and I could lay the loops flat. Bummed that I could not put the cover back on the cargo tie downs - but they did not fit either way. I have a mat in the back that covers them anyway.

I like these panels but there are some issues and one thing I didn't understand about installation. The issue is that when installing, you will get blemishes on the powder coating and they will show. I don't like that at all. The end closest to the rear see are way to close to the side panels and because the screws are too long, they press up against the panel scratching them which I also don't like. I am not sure why the screws are so long? Lastly, because the feet of the panels connect over the cargo brackets, the hooks don't lie flat and so they stick up and so nothing you put in the cargo area will lay flat. Because I have a dog bed in the back, I just removed the brackets.

These were easy to install, and feel really sturdy when in place. I carry large flight cases in the back of my bronco and was wanting something to protect the plastic from getting beat up. I like that they use the factory mounting holes and don’t require drilling.

The media could not be loaded.  Install was relatively easy. Instructions were decent, but a little outdated. Came with extra parts and no explanation as to who might need them, but everything mated up well. I installed their rear window panels at the same time and I’d recommend doing it all at once if you are planning to go that route. They overlap and use the same hardware so it’ll save you time.

They are made well and serve the purpose needed. The install is definitely not as easy as described and the instructions are very high level. Be careful scratching your plastic when you install, and don’t pre build without leaving the bolts semi loose. Lots of adjustments to finalize the install. I recommend these but give it a couple hours to get it right.