300mm LED Light Tube Linear Accent Light Strip Lamp Bar DC 12V 24V Power Saving Energy for Low Volt Lightings, Home Ceiling Under Counter Cabinet Cupboard, Solar Marine Boat Yacht RV - Warm White, 4W

Connetto a batteria 12v All'inizio funziona dopo poco viene fuori il fumo Tiro via la placca di ferro dove partono i cavi e mi ritrovo i cavi così. Prodotto buono ma pessimo per la sicurezza.

The product description for the warm white is not correct. From a power consumption point of view, this light uses less than 1 watt, while the cool white uses about 4 watts at 12 volts. The actual brightness seems proportional. While the light is much dimmer and uses much less power, this worked out very well for me. From the product description it was hard for me to tell what I needed, so I bought one of these and one of the cool white. I ended up using both over the dining room table in my backwoods trailer, adding an extra switch so that I can choose one or the other. I also can do both, because sometimes mixing cool and warm makes a nicer light, but I haven't found that to be useful in this case. While the cool white lights up the area really well, this warm (not so) white is great when I want a more subtle lighting experience. It lights up pretty well, but isn't great for reading or doing some other task where full light is needed.

Worked awesome. I used them to replace F15t8 tubes in a rv light. Love the colour (daylight), just as bright or brighter than the original, and took about 15 minutes to bypass the ballast in original light. I did a second order to replace a second light.

Fantastic!! Wired thru a switch to use in my camper as a small bathroom light. Works great, just enough and not too much light. I'm able to read by it. It is slightly yellowish. Wish it was more of whiter light..

I bought 2 of these 24V LED stripa for my 3D printer. Been running them on the printer for about 8 months when today the lights on one strip start flickering. While I'm watching they go out, smoke starts coming out the end of the tube, and there are flames visible inside. I killed power and immediately disconnected the string of lights. The other strip is still fine though honestly not very trusting of it after this event. These are hooked up to a genuine meanwell powersupply though a big tree tech skr 1.4 board. The power supply and Baird are not the issue as the other everything else on the printer is running fine. I would stay clear of this product as this is a definite fire hazard.