CIARRA CBCB6903 60cm Visor Cooker Hood Undercabinet Hoods Wall Mounted Kitchen Extractor Fan 600mm Top Vented Range Hood

Looks good and easy to install. Great light and it’s quiet

nice product

We have not had a cooker hood before, works great, reduces fat smoke and cooking smells pretty well. Down side it doesn’t look as fancy as some but it is a reasonable price and does what it claims !

I read the reviews about this having no power but I just used it for the first time frying chicken and it was perfect. Installation was easy (our extraction goes externally) and it looks modern. Noise is what you’d expect from a fan motor: not very quiet but not too loud either. You can still talk and hear the radio

Quite easy to fit, didn't have to use the supplied mains adaptor as hard wired into existing supply. A little noisy but seems to do the job. If you are using the recycling method you will need to buy the charcoal and grease filter which cost me £25 but there was enough for 2 sets of filters.

This seemed ideal to replace my faulty Electrolux hood but sadly when it arrived and I unpacked it found the metal casing feels much thinner and the tabs for opening and closing the grill again feel like very cheap plastic compared to my existing one...to top it off there was notable dent on the front top edge which meant I have had to send it back.Well recieved the replacement unit and must say while it does the job installing it was a right old faff. the extractor outlet is actually closed of with a disc of metal the same as the rest of the outer casing this is actually welded in place by 6-8 tiny spot welds. I managed to pry it apart using a large screwdriver but given the thinness of the casing material do thsi too roughly and you will dent the unit (wouldnt be visible if attached to an overhead bridging cupboard unit but thats beside the point. Then there is the factory fitted plug which cannot be removed- far from ideal if you want to thread the cable through a single drill hole to reach a concealed power point.....I did end up dismantling the unit to see if I could remove the cable from within the unit and loop that through the hole and reconnect it but the two pin terminal that connects internally to a circuit board was too wide so I either had to make a bigger hole in my cupboard or cut the supplied power plug off and loop the cable through the hole to reach the power point then install a new plug of my own.Suggest paying a bit more for a more robust piece of kit.

Good

Works well . Speed good noise level is a bit high.