LASER TREE Laser Engraving Module, 5W Output Optical Power 450nm Laser Head for CNC Laser Engraver/Laser Cutter Machine, DIY Laser Engraving Tool Suitable for Wood Metal Acrylic Paper Etc

The laser is amazing! I've tried it out on some very thin bass wood, and it cut cleanly through it. I also used it to engrave the same wood, and the results are very precise and impressive.

Llego muy bien, en buenas condiciones.

I bought this to replace a 5w laser that stopped working.This module works better than expected.The only Issue I had was that the cable that came with it was not wired correctly, I used the cable from the other laser.Would recommend this product.

So far it's a great laser. My only set back is the wait for the control board that I ordered separately. Which I used one from another brand till it came in. But great laser from my opinion.

I bought a vevor 5w laser engraver. After a few months, the laser died. I replaced it with this unit and cant be happier. This honestly cuts better and seems to have more power than the previous one ever did.

I purchased this laser based on the idea it would cut 1/4" plywood. It will not! It does not do any better job than my current laser does that is just 10% of the power. The most frustrating thing is the manual has no way to contact them phone or email. I would like to make sure sure my setup is correct. DO NOT BUY THIS PRODUCT!

Is easy to use, but you need to check the cnc3018 driver. The driver's pin assignment was not the same than as the laser.Therefore, i needed to swap the cables.I don't know what would have happened if I had changed the cables incorrectly.

I bought this to add the laser capability for my 3018 CNC. The module was easy to mount as you replace the router spindle and slide the laser module in.I highly recommend buying the LASER TREE 20W 40W 80W Interface Adapter Board Transfer Board and the COOLM 12V 4A Power Adapter AC 100-240V to DC 12V 4000mA Power Supply 48W Adapter. The board was needed because my motherboard would not supply the wattage needed for the laser and the adapter corrected this. To use the adapter, you will need the correct cable to go to the adapter board from your motherboard, then use the supplied cable from Laser Tree to go from the adapter board to the laser. The adapter also solves the problem of going from 2 pins on the motherboard to 3 pins on the laser if your mother board is equipped that way.I have engraved many items and hope this lasts a long time. I have engraved tumblers; tile coasters and wood plaques and the laser has always had enough power to get the job done.