DVPARTS Oil Pressure Switch 0L2917C 0C3025 0C30250SRV Compatible with Generac 0G6820 10 PSI 1/4-18 NC

Even though this part wasn’t a direct match to what was on my 10 year old generac 22kw generator. It works fine. The spade lugs fit on the tabs. It cleared the low oil pressure alarm/code and generator is running fine.

My generator failed on low oil pressure. Was hoping it was just the sensor and it was. The new sensor had a much bigger opening for the oil pressure to be measured. Took 5 minutes to replace.

Worked perfectly, got my generator back on line.

Easy to install. Original wires fit perfectly on the sensor. This replaced a faulty sensor and once installed, I was able to start up the generator once again. Bring on the hurricane Beryl!

My oil pressure sensor failed just when I needed the generator during a power outage. I took a chance and disconnected the wires on the faulty sensor just to get the generator to keep running. This is a bit risky since it takes away the low oil pressure protection so I wouldn't recommend it for the long term. I ordered two of these, one to replace the bad one and one for a spare in case it happens again. Easy swap out even though the new sensor didn't look exactly like the old one. We'll see if it lasts. The price was very reasonable compared to one from Generac. Be prepared for a bit of oil to dribble out of the fitting during the swap.

After 2 yrs and 10 months I noticed the red light was on on my generator. Opened it up and found a lot of oil on bottom. Filled it back up to trouble shoot and oil is gushing out of sensor between plastic and metal. Total junk. Lear es my lesson

This part went out on our home backup Generac Generator. It is 10 years old now and this is the part that usually goes out. Original part has been replaced and generator works great. Purchased this extra one for a backup.

This fit my Generac standby generator. Also have a spare for next time it may spring a leak.

On inserting part it felt loose and seemed like it might not hold, but so far so good. It does appear different than original part but it does work properly. Hopefully it will last longer than a year. Another reviewer said it lasted up just over a year. Time will tell.

Work great as a replacement part for my Generac Guardian 14 KW. Will buy again as a spare part.

Fit perfectly. Works fine. My only issue is that the wire connection tabs are a bit flimsy, so be careful pushing on your female spade connectors. If the are really tight and you push too hard, you risk bending the tab over sharply and having it break off because they are made of such thin metal.