Molex to 3Pin/4Pin Fan Adapter, 12V PC Fan Adapter 4Pin Molex to 4 PWM Splitter Sleeved Braided Cable UIInosoo for 3 Pin or 4 Pin Computer PC Case Fan Power Supply 11 inch

Does the job The product arrived as advertised and met all my expectations in terms of quality. It performed just as described, and I had no issues using it. I would definitely purchase it again if I found myself in the same situation.

Nothing complicated here, the cable braiding is good, the plugs hold firmly, its inexpensive and works as expected. I'm using it to drive four Rosewill Hyperborea 120mm fans which its handling perfectly fine.

Worked exactly as I need it to work, adding extra fans to a small case and a motherboard with few connections.

I was just glad this kind of thing still exists. I had to add 4 fans just to offset the increased gpu temp

The crimp connector holding the bundle of fan ground wires to the Molex connector were terrible. It appeared that the wires were only held by the two crimps that were suppose to hold the wire insulation to the Molex connector. Eventually the wires came loose so I had to strip them more and solder to the connector. If the pert is assembled correctly, it would be difficult to fail.

I needed a good quality adaptor to energize my 6" fans. This on is good.

Just what I needed. My psu has molex connections for case fans and the case fans are 3pin

Three of my old case fans literally bit the dust (so much) after many years and environments: salty humid sea air to dusty dry air. They were connected via molex and that's not very popular for case fans now. As I have no motherboard space for these fans, I wanted to power the new fans via molex. I want to try this configuration out before trying the mutil fan adapter that connects to the CPU fan pins on the motherboard - I don't know if I want all fans to be directed by the CPU needs as I have a CPU cooler that does very well. Simple solution was this adapter which I found was fine. The only quirk was what another reviewer said: the 2 pins on the molex side are not specifically mounted to the exterior plastic so take care in plugging into the female molex coming from the PSU. Last comment is that a ziptie or twist tie was helpful when done connecting - the cords are long enough for anything in the main case, almost long enough to put behind the panel that holds the motherboard - my case case a false back with some slots to run long cords away from the main space.

worked as it should

Works as describe!

All of the pins are loose in their sockets. Required a lot of fiddling to get them to line up with the holes in the mating connectors and assemble without bending the pins. Would not buy again.

Broke when plugged in. With in 3 seconds.

The cable on the molex side was loosely held and came out. So I couldn’t use it.