Pioneer GM-D9705 2000W Class-D 5-Channel Amplifier with Wired Bass Boost Remote

Hooked it up to 6 of the 5 1/5 inch speakers and a 10 inch sub. I had to turn the gain to zero cause it just out preformed the Tampa 3500 watt sub amp to much. I have ran it as loud as it will go just under distortion for hours at a time. Not a glitch no cutting out. Just amazing sound. It's a dam good amp. If your looking for an amp to kick the crap out of. This is it in my opinion ( and I kick it hard lol) Except now I need a better sub amp

Im not big on giving reviews, but this amp deserves one. This is a great 5 channel amp for the money. Put it in my 2000 jeep wrangler with some kicker speakers, in front and rear, and a pioneer 10" sub in a sealed box. It would work with factory speakers, but your not getting the true benefit of the amp if you do that, and you may blow the factory speakers, due to the wattage of the amp. I was very surprised at the detailed clarity of the sound. This amp packs a punch, and hook up was a breeze, if you know anything about installs. The subwoofer channel puts out plenty of wattage for a pair of subs. I only wanted a small enclosure behind the seat, so I only went with a single 10" with dual 4 ohm voice coils. That way I could parallel them and put 2 ohms at the amp. It hits really good and clean in my jeep. 2 subs would sound even better, if you get the impedance to 2 ohm. I have always had multiple amp systems in all of my vehicles, but wanted simplicity on this one. It is a perfect set up in my opinion. That will give you exceptional sound quality for the money. I ran 4ga power and ground. I would not go with 8ga. The amp would probably run hot from the extra draw, and make it work harder. I cranked the system for quite awhile dialing everything in, and it barely even gets warm. Buy it!! You wont be sorry. Its the best I could find out there dollar for dollar.

Dope...... this is such a small footprint for a damn powerful amp. Dyno at 4ohm channel a and b made 100w at 14.4 rms. Static test. Sub channel 2 ohm made 610w end. Didn't do dynamic this makes more than rated so be aware for your door speakers if you gain it right and max it out it will put 100w not 75. Just know what in case you are buying it intending 75 watts per channel. Anyways sound quality is average for a d class and it works well. It does get warm for a d. Hope you enjoy yours. She will be slamming my kicker solobarric for the foreseeable future. In not happy with the ref series 6x9 I ended up going with. Wanted ct meso but i think screw it in gona go all focal for my next upgrade

we purchased x3 of these Amps. they pack a punch for damn sure. great value.. we did one on my 2017 ram 2500 power wagon with stock 8.5" touchscreen & skar 3.5" dash 6.5" components front & 6x9 rears and the dual 10" JL audio box under the back seat..and this amp just slams all the speakers & subs. on my son's 2000 Toyota 4 runner we did almost same setup but with a aftermarket pioneer deck with epicenter & it's pretty insane for a single amp. wife's jeep jk I chose to try the high level speaker input and was very wary of this because back in the 80's -90's High level speaker input would have the distinctful pop as the amp goes on. this pioneer amp High level speaker input has some kind of micro chip in the shrink tubing.. but I'm pleased to report that it doesn't make the pop noise & it still sounds just as clean! btw when you do high level you don't need to run the remote turn on wire that audio signals turn on & off the amp when it senese the audio signal, that was pretty damn cool. I would definitely buy this amp again!

Gets hot, and goes into protection mode very easily, I thought this amp would work out better . But kind of strange because it's almost 150 less then Crutchfield and other certified dealers. Beware! Sending it back asap.