Premium Mini Snap Swch, 3A, SPDT, Pin Plngr

When the switch began to fail on our cat's litter robot II I tried to order a replacement, unfortunately they are no longer in production so the switch was not available from the manufacture. I did some research and found this one to have very similar specs and was a few dollars less. Install was easy but I did need to glue it in place as the Litter robot design allows too much play at the switch mount point which can cause some erratic behavior. (I don't fault the switch, it just needs a more solid mounting. Now our cat (and wife) is happy that the robot is back up and running perfectly!

This was a direct replacement for my 10 year old Whirlpool WHES40 water softener. The original switch was still making electrical contact when tested, but the little white plastic plunger had worn down to a point that it was not making contact after the rinse cycle and showing an error code "ERR3". A bit of research and a detailed inspection pointed me to the switch. This switch is much cheaper than a new softener! I replaced the switch, did a manual recharge, and all worked perfectly. Simple repair, quality switch, form Honeywell.

Worked perfectly for what i need it for. 4 stars because I used it to replace the position sensor on a Kenmore Ultrasoft 425 water softener, but the paddle that is hinged on the switch (see 2 slots to the right of white toggle button) was not included. It is supposed to be in the middle slot. I simply used the old one, but it involved cracking open the housing about 2mm to fit it in. works though.

The housing right next to the button finally gave way on this exact switch in my Kenmore water softener. Ordered a new one with the same exact part number, works like a charm. Hard to find part! Sears parts department was the opposite of helpful on this, and wouldn't take the original Honeywell part number.Seems like a solid switch. I don't fault the first one for failure given the coat of salt dust everywhere. I think this softener is close to 15 years old.

On time delivery and worked like a charm to fix our Kenmore water softener

Used this to repair my Kenmore 425 Water Softener that has been in my house since 2002. The softener was displaying an Err 3 message. This part was installed by removing 4 screws (2 to loosen the motor, 2 for the switch) Search Utube for videos Err 3

This is essentially identical to the OEM switch. The "button" may be difficult to see in some photos but this is the one! The actual replacement process took <5min and my water softener (Ultrasoft 880) immediately worked again.Fast shipping as well!

Worked right out of the package. This inexpensive switch was the problem and I was able to repair my Kenmore Ultrasoft 800 water softener showing Error #3 within 15 minutes by simply removing and reinstalling 5 small Phillips head screws