WidgetCo 1/4" Brass Shelf Pin Sleeves (Qty 100)

Like them a lot

These arrived on time and look good. The pins fit well. But sometimes they are a little loose in a 9/32 inch hole. I put a dab of glue on those.

Order two bags second one had some very tarnish Brown ones.

UPDATE 02/2023 - Dropped from 5 starts to 3. Shelf has been in place now for nearly a year in an environment that stays within a few percent of 45% humidity year-round. Every one of the "brass" sleeves has a layer of rust...fine and powdery that rubs off on your finger in a very distinct reddish brown rust dust. Too late to do anything about it now--would likely cause damage to the finish to pull them back out and replace--but I won't use these again.ORIGINAL REVIEWThese are well made and work well. However, be aware that almost any shelf pin jig is going to leave you with a hole that's too small. These sleeves are meant to accept 1/4 inch pins, which means the size for the hole in your cabinet needs to be 9/32 inch to accommodate them. Most shelf pin jigs (e.g. the Kreg shelf pin jig) will make a hole exactly 1/4 inch in size, requiring you to bore them a second time, freehand or with a drill press, with a 9/32 inch bit.

Good product. These are a classy touch to the interior of any nice cabinetry where you are using shelf pins. They also perform a structural function in that they help spread any load the pins are suffering AND they cover any minor splintering from drilling. Order these not for how many shelf pins you'll have in your cabinet but by how many holes you drill. Nothing looks less classy than to open a cabinet and see nice brass shelf pins inserted into nice brass sleeves, but yet the remaining holes (for adjustment) are bare and left exposed.

Did not hold the 1/4 pegs the way i thought it would. I ended up just screwing the shelves.

These fit and work perfectly.

Looked all over for the right size, and finally found these. I use any color.