Baseboarders Basic Series 4 ft (48 in) Galvanized Steel Slip-On Baseboard Heater Cover, Rust Resistant, White, for Hydronic Hot-Water Systems

I recently upgraded my baseboard heater covers in my bedroom. This corner cap leaves my baseboard heater covers looking great. No tools or hardware was needed. I have galvanized steel covers in both of my bathrooms. I installed both of them approximately 10 years ago. To this date, they have held up perfectly. By this I mean, they have never rusted. They are worth the price.

Should have taken a before picture but I was too excited to get the broken and rusted old covers out of there! This has made my bathroom look so much better! Ordered one for my bedroom now.

Just remodeled a bathroom that had custom hand carved wood baseboard covers right next to the toilet. We wanted something that was easier to clean and wouldn’t stain and this was a perfect solution.

Awsome for my bathroom! Easy to use and looks great when done!!

This baseboard cover is great product and such an upgrade over the terrible Slant/Fin covers that were there before. I actually bought one of those Slant/Fin replacement covers from Home Depot and was so turned off by the ugliness (even of a new one) and the complexity of installation with the whole housing that has to slip behind the heating unit, etc.. I decided to look around for an alternative and found these. These base boarders are SO easy to install, literally 2 brackets, I screw each (see picture). They seem very well made. Wish I could replace all the covers in my house!

These could not be easier to install. They just slide right on and make my old baseboards look brand new! I just got two for a bedroom so I didn’t mind paying a little more but these would be really expensive to do a whole house. I also wish they were just tad bit longer as mine don’t go all the way to the floor. All in all I’m happy with them.

They look good but expensive and easy to install. About $500-$600 for 1 room about 30 feet purchased ,including corner brackets,end brackets and joiner bracket

Originally this came severely damaged and the seller sent me a new one right away! It came two days later and was perfect.I really like the way it looks on my heater pipes. The old one I had had a bottom and this one does not, but the cover is longer I think it looks much better. I like that the vent holes are on the top and the side and my old one was not like that. So far, great product and super easy to install! I left the back of my old one and it slipped right on top. Took me five minutes to put in.