FlightPro Aviator+ Yoke Mount for Phones & Tablets! Fits All iPad Models - Mini, Air & Pro!

I purchased this product so I could place my Galaxy Z-fold on the yoke and use the Garmin Pilot for navigation. This is a great product - very handy, configurable and easy to attach and detach from the yoke. However, after a few months of service the threads for the yoke clamp screw got stripped and the clamps could not be tightened around the yoke. I contacted the customer service through email and they responded within a couple of hours and immediatley agreed to replace the defective part, no questions asked. They didn't even ask for the defective part to be returned. I got the replacement part within a few days, that was shipped to me at no cost. I couldn't have asked for better customer service. In conclusion, the product is great and customer service is awesome. I will definitely recommend this product to all pilots out there! Ami

Mount clamps onto the yoke shaft great but the arm of the mount flops no matter how hard I tighten it down. I only have it holding an iPad mini so it should be able to at least handle that weight. Maybe I just got a defective one idk. I do wish the arm was a little longer to better drop the ipad over the yoke front.

Amazing customer service and the quality is really good. Just email them if you have any issues. This arm wasn’t fitting my C152 so i emailed them and they shipped me a longer and bigger one right away free of charge.

The yoke mount rarely held my IPad tight, and it would often need to be re-tightened during the flight. After just 2-weeks of use, the ball/gymbal (part that connects IPad holder to arm) totally just broke off. If this device was supposed to make my flights a less workload environment, it did everything but that!

Strong, well made, not bulky holder. It could be a 5 , but the ball attachments tend to jiggle loose allowing the I Pad to rotate. In weather during an approach it is unsettling. Use of a strong adhesive cement worked. The ball joints themselves are easily fixed as intended by tightening. it is the screw in backing that was a nusence. . Easy fix and a good purchase

The first item I ordered did not fit my airplane quite right. This is NO fault of the seller as I should have known better given the make and model of the airplane I fly. The holder I received was small, solid, and really secure when put together, so I really wanted it to work. I emailed the seller and within just a few hours they resolved my issue and sent out parts that would fit the airplane I fly. Went flying today and it was perfect. No hot IPad on my lap in the summer and always just a glance away. I wish I would have bought this a long time ago..... Great little device and incredible customer service. Will definitely be shopping this seller again in the future....

It had 1 job and it does not do it. It did not even hold my i pad mini in place i had to add rubber bands. I only use it on my sim. I did not trust it enough to use it in an actual aircraft. - student pilot.

This product (although well priced) needs a lot of engineering and improvement. It doesn't hold itself in place no matter how hard I tighten the screws. Products like these are supposed to reduce pilots cockpit task... this one increases it! One time I was turning from base to final (on landing) and the whole mount started moving around. This caused me a distraction for couple of seconds and I lost track of my power-setting and had to go around. My CFI was really unhappy and took over the yoke and yelled at me to remove the mount in flight. Really bad day for a student pilot. I will not be returning this product. In fact I was just so upset after my CFI yelled at me that I just threw the mount in the trash upon landing. Again, I realize that this review might be hurting your business and I sincerely regret this -- but I find comfort in the idea that this review may save a fellow pilot's life one day. I wish you all the best and advise you to re-engineer the product significantly. Its just not there yet and should not have been set for mass-production. You may wanna make the steel pivot points (balls) bigger and use less slippery material. This might solve the problem. Thanks