Governor Removal Kit for Predator 212 Non-HEMIspherical

It's wonderful light weight and bolt and go. Always check your squish clearance and lap the flywheel

Easy to install but haven’t put it to the test.

These are very nice parts

Okay people. This kits is bad ass. Highly recommend. Only thing I wish the told you the torque specs on the parts. But if you are building the 212 get it so work it.Rod cap bolt 130 then 150 then final 170inlbs or 14.1 foot poundsFlywheel is 65 foot poundsHead bolt 14 foot pounds. You don't have to remove head to install rod. If you push the piston down until you get the snap ring out. The cyl will keep the rings compressed as long as you don't push it to far down the on the cylinder

I spent over $300 I'm parts that all broke upon my installation I spent at least another additional $200 in the correct tools just to have parts break I try to install in the connecting rod as it states and the part snapped on me the head snapped straight off and there is no way to save the connecting rod nor get the bolt out without doing some serious remachining the on the connecting rod I talked it to 175 ft pounds as it stated just to have the 1/4" 12 bolt snap on me I'm very disappointed and very frustrated the fact that this did not work and that I wasted so much money there's a way that I could either get a replacement part for what happened or your refund that would be a serious relief

All of the holes for the gaskets were too small, and yes I have a non hemi. The metal head gasket didn’t fit and when I tried drilling the holes out bigger the whole gasket wrapped around the drill bit. Only a few of them fit. Every thing else fit perfectly

Amazing quality! The machining process is something they have figured out. Not only are the parts solid, they looks so good. It sucks that they have to be covered up.