1 Thick NMO Mount to Short Type 1" SO-239 Adapter PBH Packing

I used this to mount a GMRS antenna to our motorhome roof (which has an aluminum top) and this worked perfectly. I like the fact that the NMO part can be tightened with a standard wrench, and it also has an o-ring to seal against the surface that you are mounting to. I added some caulk to this ring just to be safe. One thing I will note, is that if your surface material is more than about 1/8 inch thick, it will start to take away from the threads that the bottom UHF connector will need to fully attach.

Product itself is fine, but really should have included the $0.10 rain cap - or specifically mentioned that it isn't included. Since this mount is permanently attached to the vehicle, I (like many I assume) keep their antennas off when not in use so you can go through car washes, etc.

I needed to get one that would fit in a 1/4 inch piece of metal. This worked out great and I can put a 90 in and not interfere with the smaller box tube space.

I'm very pleased with this because I had a specific need, I built my antenna configuration around my Jeep Wrangler spare tire antenna mount, not the best way to build a setup, but that's what I did.The problem is the hole for the antenna is 1/2" and I could not find the OD for the adapters, it's not even listed for this one, BUT it does fit, no problem. It appears that the adapter companies are assuming the customer like me would know the specs for the connector on the cable. I'm guilty I did not know the specs.I bought the adapter to go with a Browning BR-180 for my ham radio.

These are great to have on hand , that way you can make the length of coax cable u will need . NMO antennas wheather its a 1/4 wave or 5/8 s antenna will allways perform good when mounting in the center of rooftop of your vehicle . I would buy from again / Thank u

Used to attach a Nagoya NMO-72 19" antenna and to a "Bingfu Vehicle CB Radio Mobile Radio Antenna Mirror Mount". Mounted onto 2018 Textron Wildcat X Ltd.

Great little mount I'm sure I'll use but not in my vehicle because of space.

Replaced a SO 239 mount. Cut it off and installed a PL 239, put the new mount in the hole and screwed on the cable.Easy way to convert it to NMO, didn't have to pull out the cable and pull in a new one. On a tire mount bracket back of the Rav-4.3 Rapped a little tape on the connection -----job done.