The No-Screwups Remote Control Holder by Mount Genie (White): Wall Mount with No Damaging Screws or Tape. Installs in Seconds on Any Light Switch. Great for TV, Ceiling Fan and Roku Remotes.

Super easy install. I added double sided gorilla tape to give it extra support. It took 3 strips stacked, but worked perfectly.

Such an awesome holder. No holes, no motivations. Just loosen, slip behind and tighten back down. Amazing!

Took less than one minute to install with a small screwdriver. Holds a chairlift remote by the light switch without being in the way. Does lift the switch wall plate slightly away from wall, though not obtrusive. Color is not a match for our ivory plates, but not a seriuos concern. Measurements of product were accurate. Leaves no marls; could be easily and quickly removed and placed elsewhere without needing reparir to wall, paint, or switch/plug cover plate. Purchased two; one for top and one for bottom of stairs. Would not have worked had light switch not been convenient, but would purchase again if location warranted.

Easy to install, won’t damage wall at all once removed, fits ceiling fan remote perfectly; a little expensive though for what it actually is.

This was perfect for what I needed. A holder for my ceiling fan remote. Every store I went to wanted to sell a remote, no holders only. And this one is a double bonus in that it installs easy & doesn't require extra holes in the wall. It's a tad large for what I used it for. Might hold a small TV remote. But does the job at a good price as well as solidly attaches with no worries about it falling off the wall.

I installed this as I kept losing remote controls. It took less than five minutes to install and it looks great! Also, no clutter! This is the second one that I purchased. I love it!

The product looks good and installs easily, but it is too bad that it only comes in black and white. My wall plates and switches are all Light Almond. It would be great to have this in more color options.

This holder is a good size to hold a normal size remote control. I really didn't like the installation bracket that attach the device to a light switch cover. The bracket is too thick to allow the switch cover to sit flush on the wall. See attached picture. I tossed the mount part and used double sided sticky tape to attach the holder to the wall. This way you are not limited to mounting the holder where there is no switch.

I purchased this holder for a bedroom where we have installed Philips WiZ smart WiFi enabled light bulbs in the light fitting. I bought the remote control and wanted to keep it accessible from the bedroom doorway. There are a couple of negatives but I'm still glad that I purchased this item. The remote control holder is quite expensive for what it is - essentially just a plastic box - and I can only fot the one remote in it. Also my UK socket is square so the flange that sits under it sticks out slightly at either end. However it makes it easy to locate the remote and dim the lights from the door at bedtime so it works perfectly for our requirements. If you have a 3D printer you could probably print one at much less cost.

Great and easy to install

This product is exactly as described. Very convenient and attaches to switchplate as said without damaging walls. Very great idea, its only plastic and would sell many more if they weren't 20.00 each, the only drawback is the price is a little steep for the material.

Este artículo fue fácil de instalar y es muy seguro. Es una solución perfecta para un soporte a control remoto montado en la pared que no deje agujeros ni marcas en la pared

Recomiendo medir bien si lo que deseas es usarlo como en la foto. Mis necesidades eran distintas entonces no tuve problema.