OSD in Wall Speaker Selector A/B Switch, Select from 2X Speaker Pairs White AB12

Perfect solution for me. Now I can switch music from my garage to my tractor shed without having to play in both. The A/B switch fit perfectly inside a single nail-on gang box using 18 gauge speaker wire. Also, the picture shows 2 inputs and 1 output...just reverse it for 1 input and 2 outputs.

Needed 2 for a project and had tried another A/B switch that didn't work out, so I ordered 1 as a test. It worked just fine and appeared to be of decent quality, so I ordered the second.Second switch did not work, and after testing with my vom closer and closer inspection I found a defective circuit board and cold solders at output block connect to board. Returned item and reordered. Hopefully, that was a rare defect.

I really like this one. Comes with 3 different shades of wall plate and button(white, beige, and a darker beige). terminals unplug from unit to easily connect wiring. Can be used to run one pair of speakers from 2 different sources (one at a time) , or 2 pairs of speakers from one source (one pair at a time). I ran this with 2 pairs of speakers to one receiver on Zone 2. One pair of speakers in my kitchen, the second pair on my patio. All I need to do is press the switch and it seamlessly changes to the other speakers. I like the fact that it severs the connection to the amplifier while switching to the other pair so the amp does not see an impedance jump. High quality switching gear and materials.

The wiring setup of the Selector switch is well designed. It was easy to install and simple to use.

It works for 2 amps to one speaker or the reverse. Good terminals to hold wires tightly.

I was looking for a way to switch between my indoor receiver and out door TV on my outdoor speakers. This switch does the job perfectly. Installation is pretty straight forward. The speaker wire connection a a bit small, so heavier gauge wire will not fit. The only issue I had was the circuit board on the back was a bit bigger the the electrical box opening. I had to grind down the opening to get it to fit. The board is also a bit big as far a depth goes. There is not a lot of room in the box for the wires. Not a huge deal, but I was expecting it to fit into a standard electrical box.

I have not installed the two off these that were ordered, but the product appears to be well made. They come with 3 different colors of covers (almond, white, and ivory), which I was unsure when the product was ordered.

Purchased two of these for the house to switch between Living Room and Kitchen speakers and another for the Morning Room and Patio speakers. The one for the kitchen works great - but the one for the morning room isn't working quite right. These use a pushbutton style switch that switches all four wires (left/right pos/neg) to another set of outputs/inputs. When the switch is depressed, it's not fully switching the right channel on the second switch - so the morning room has stereo sound while the patio only comes out one speaker. I've verified it's the switch, because the situation flip-flops when I swap the speaker plugs. Great concept - but it does seem it will wear out/break over time with this mechanical switch.