Alpinetech 12mm 1/2" Blue 12V LED Metal Indicator Pilot Custom Dash Light Lamp

The lights are bright and work great.

Bought amber, green, and blue for dash indicator lights on a 70 MGB. Nicely made and worked great, but the LED's are too bright at night. I cut some small circles of window tint to fit just over the lights, and it is perfect. That basically makes the whole face of it look black until the light comes on and it dims it just enough to not blind you at night and still good in the daylight.

Just installed this on my 77 kz 650 cafe racer for an oil pressure light. All of my gauges and indicator lights are deleted but I need to at least make sure oil is pumping. I was concerned about the length listed because it said 4" which wouldnt have worked due to the low clearance I have in the headlight bucket, FYI actual clearance needed is around an inch and a half. The only drawback to this light is it doesnt have leads and the posts were too small to land the factory wires so I had to make a jumper with 18 gauge, no biggie. The light is definetly bright and will I can definetly ser when it's on. In my case there is a little bleak through flicker when it's off but that is to be expected with 40+ year old wiring. I'm going to go ahead and purchase the green version for my neutral light. Hopefully they will last some time

This lamp looks very well made. My plan was to use it for a charge indicator on my old tractor, but I couldn't get it to work in my circuit. I don't know why. I assume there was something wrong with my circuit design or implementation.

Very good indicator light for the dashboard. I am using this one as a "PTO Indicator Light" on an old project truck. Be aware that the screws for the wire connections are VERY small, so unless you have a set of very fine phillips screwdrivers (like for electronics or eyeglasses) you will need to purchase one.

Requires small guage wire and a small phillips screwdriver. Works well and is very bright.

Everything about this light was good, except that the nut to hold it on the dash doesn't have the same threads as the light itself. So that makes it impossible to tighten it tight. I ordered a green and red one. The green light has the right nut and threads.

I ordered this lamp to replace a bulb that failed. I had one day to work. But Amazon has suddenly broke promised times of delivery. Promise next day, get notice then it will be three days, then 5. Don't make plans!