Minwax Oil-Based Wipe-On Polyurethane, 1 Pint, Satin

I love this wipe-on polyurethane. I've been using it for 30 years. The round table and chairs, I did 30 years ago and it's still beautiful. I did the stairs from my garage into the house 10 years ago, and despite the heavy use (in and out many times a day with dog), they look the same as the day I did them. It is SO easy to apply, just wipe it on with a soft cloth! Way better than brush marks. And you can lightly buff it with a fine steel wool in between coats, as well as after the final coat if you wish. Three or four coats typically does it for me and it is so easy, takes hardly any time at all. You need to be patient, though, and let it dry thoroughly between coats. This is an awesome product! I just cannot express how much I love it.

I refinish vintage wood radio cabinets and previously had always used spray lacquer. An article in a handyman magazine persuaded me to try the Minwax Wipe On Poly, and I am so glad I did. It goes on so easily with just a small rag - no runs or brush streaks. A second layer can be applied after waiting a few hours and lightly sanding with a 220 grit sponge to create some grip for the new finish. Two coats of the satin product are sufficient to produce a protective coating with a nice soft sheen - nothing at all like the gleamy gloppy finish created by using standard poly. Just be careful to shake the can periodically while applying.

Gives a beautiful finish, i used the warm satin. So happy with it! Easy to apply. I have several other ounces i need to refresh and I will use this....

The newer version is less glossy which I wanted. Dries instantly in seconds so not that easy to work even.

Great product.

Wonderful product!! Easy to use, low odor!

Why did you pick this product vs others?: Used this product for years, very satisfied. Being able to wipe it on is what sets it apart. Smell: It's not odorless but mild compared to many others. Coverage: Coverage is good but understand it's made for 2-3 light coats not one thick coat. Smoothness: Like most fine wood projects light sanding between coats will get a superior result. Dries quickly: Dries to the touch in a short time but I always go 24 hours between coats. Finish: The satin finish leaves a light classy sheen.

I use this product for guitar necks. It build up nicely with just 4 thin coats. It’s very forgiving and easy to spot repair. I apply with a clean t-shirt cut to the size of a credit card, then fold up tightly, dip into a clean cup of Wipe-On Poly, and apply. You have complete control over your technique. If you want an oiled hand rubbed finish, dip a little and rub it in like you’re cleaning the wood with an oil. If you want a flatter built up finish, dip more and apply by dragging the cloth across the surface in long consistent strokes. It’s self leveling and dries like a sprayed finish. It’s fluid enough to limit drips. If a ridge develops that too levels out to the point that a light sand will remove without sand throughs as long as the grit is light (800.) Fully cures within 2 weeks.