Thermoplastic Denture Adhesive, Cushion and Reliner

This is not an adhesive, it's a reliner.This is 1000 times better than the 2 parts kits that you mix together. 1000 times less messy, and it has a much longer work time. It's easy to use, and soft enough for quite a while after it's applied to dentures to easily cut the excess off and reshape it, once happy with the fit you put it into cold water for a while to set it. I even popped my denture back in really hot water days later to soften it up slightly to rework the edge the first time I applied. I needed to correct my handy work as I left one side too deep so it dug into my gum, not that it was hard, but it's firm and rubbed a little. The two part kit I had used in the past worked, but ruined my last dentures, they needed replacing anyway so no big deal, but the mix kits chemicals etched into the plastic and made the gum part dull looking. This is like a soft pliable elastic gel when applying, and doesn't run all over the place, so it's very easily used on partials. It's also really easy to remove for replacing when needed, unlike the 2 part ones, which I had to dremel off the insides of my old dentures in places to remove it as the 2 part mix kits turn to rock abd is a nightmare to remove. This single part one stays softer, but not soft and spongy. To remove this, you drop your dentures in quite hot, but never boiling, let them sit for about 5 minutes, and it just easily and completely pulls off in one strip (no, drinking or eating hot food doesn't remove it). The taste of this when first applied, isn't that bad, and the chemical taste doesn't last for days, only a couple of hours at most, unlike with other relining kits who's nasty taste can last days. It burns/stings a little when first getting it set up, the sting is worth it (a minute or two) but that quickly vanishes with a few mouth rinses with cold water. Application lasts for a good month or more on my bottom dentures. WITHOUT this gel, my bottom dentures would be out more than in, even using adhesives.I still use adhesive with this reline gel as my gums are shallow, but my teeth stay in all day now as theres little to no movement using this, so the normal denture adhesive doesn't wiggle/squish out during eating. I can glue my bottom teeth in first thing in the morning, and depending what I have eaten during the day, not chewy steak as that will deffinatly loosen them by late afternoon/evening, they are usually still in place and stuck enough to eat my evening meal most days.Some evenings/nights I have to fight to get my dentures out as the every day adhesive is still there, and I no longer fear the dreaded sneeze your teeth out either, yep, it's happened 😂😂😂Like anything, it takes a while to use it correctly but it's so workable, even the first use won't end up in the bin. I suggest you use a small Pea size bit and try it on a bit of hard plastic and play with it to see what the properties and feel is like before actually using it on you dentures. This seems expensive for the size of the tube, but a little is all you need. Watch the few YouTube videos on how to use this, but most are in German (might have subtitles), but the video without sound was enough for me.I'm never going back to the 2 part kits. I also hope this never gets taken off the market and I wished had found it years ago instead of struggling with my bottom teeth and the pain and rubbing caused by them flip flopping about once the denture adhesive wore off in an hour or so.The people saying they used a half or whole tube in one go, either seriously need to get new teeth if the gap was that big to need a whole tube, or they have tried using it like denture adhesive rather than a reliner. I have used mine 4 times now and still have at least 2 thirds of the tube left and it's probably 2 to 3 times the size of the tiny travel size toothpaste tubes, and with the length of time it stays put, it really isn't expensive. Just read the instructions a few times, and a few times more to make sure you know what you are doing, watch some videos on using it, take a small Pea size prepared gel to play with at first and you really can't go wrong. I hope they never take it off the market as its a life saver.

Dinabase7 is not easy to use. Difficult to squeeze from tube. When contents reach air, it hardens. Not easy to spread on denture. The tube is very small and costly. Very disappointed with purchase.

A bit hard at first to apply but the more I use it the better it getsIt really held my dentures in and last d 7 days

Very small tube for the price but did the job.

Definitely not worth the money doesn’t stick burns your mouth gives off a strong solvent smell and taste

I was so excited when I read the product details. In reality, this product is useless. I followed the instructions to the letter, ended up with a sticky mess in my mouth. Unfortunately, I waited to use this, until I had used up the product that I was using. This was a mistake as I can now no longer claim a refund for this completely misrepresented product.

This stuff is a bit tricky to apply, but easier with practice. It does not stick to your mouth, only to the plastic dentures where it forms a lining which accurately and precisely matches the contours of your gums, hence creating strong suction between denture and gums. there is no nasty sticky residue left behind when you remove the dentures. it lasts a good seven days before re-application is needed. I do find it difficult to scrape it all off preparatory to a fresh application, but since this is only needed once a week, its not too bad. I've ordered more anyway.

After three days eating and drinking, still had a 'stale bread' type after-taste. Followed instructions to letter. Allow about 50 minutes to prepare and fit.