EinhellCircular saw accessory Aluminium guide rail 2x1000 mm (compatible with plunge saw & Einhell Expert handheld circular saw, precise and straight cuts, gripper strips for a non-slip underside)

Very high quality. Works a dream with my Einhell plunge circular saw. Good value for money.

Needed to trim a bunch of doors and kitchen plinths in my new build after flooring went down. Quite a few of the doors had been trimmed uneven so if I had just used the built in guide on my circular saw, my cuts would also be uneven. This rail guide however let me set my cutting path accurately and clamp it down, it was very sturdy guiding the saw through the cut. Nice even result, definitely worth buying this rail set.Some reviews said they didn't get the clamps which was a bit concerning, but mine did come with them and they work great.The rubber on the cutting edge was oversized, however a pass over the guides with your saw will trim them to the correct length.Joining the two pieces together was needed for one of my tasks (pictured) and it does take a moment to do this but with the screws tightened they lock together very well.Used with an Einhell TE-CS 18/165-1 Li Cordless circular saw no problem.

I think the only negative I have is the clamps - they could do with a fillet piece between the upright and the parts parallel to the track to increase the sturdiness. I find that they bend as you tighten so a fillet piece would stop this. Also be prepapred for that first cut through the rubber apron - I ended up with rubber marks up the wall of my workshop which I wasn't expecting

This is fantastic.I know it is designed for a specific saw and doesn't quite work as intended with my saw but what I needed was a straight edge guide for long cuts. Having struggled for years with either freehand or trying to use a plank as a guide I had a diy job that needed to be dead straight.There are others on the market but they were more expensive, often less than 2 meters and still for specific make/model of saw that I didnt have.So for les than £50 I figured I'd give it a go.Its great. Easy to assemble, firm and doesn't move.Only 2 downsides,1) as its not designed for my saw its a little tricky too get the cut to a precise measurement (but thats not a fault of the product, ) and 2, i wish id got a second so I could do xuts up to 3 meters (turns out I needed a 2.2 meter cut...) But again, not a fault with the product, just the way I wanted to use it..This has saved me a lot of hassle and wobbly cuts.

Used this product to help cutting large boards to size. Found to be veryuseful. Clamps could have been designed better, other manufacturers have better clamps.

Perfect for an Einhell circular saw, mine is cabled and this fitted it well and is great for cutting chipboard etc and giving you straight lines

A fairly good set of tracks, but with flaws. Lock together securely and once set up (plastic edge trimmed on first use) accurate cuts can be achieved, as long as the track doesn’t move. This is the caveat. The anti-slip strips underneath need to be kept spotless or the track will be budged slightly by the vibration of the saw being turned on. Having watched countless videos of people throwing their track down (no clamping) and producing accurate cuts, this was a bit of a disappointment.Provided clamps are total rubbish and distort/break very quickly. Best to buy a better set. Overall, once clamps have been replaced and you have a way of securing the track to the work piece, it’s not bad.

While the guide rails are designed to be used with the Einhell plunge saw (and they are a perfect fit!!) my package arrived minus the 2 guide rail clamps and the hexagon key to be used with the connecting rods. I have contacted Einhell UK and asked for the missing parts to be supplied. I am awaiting their reply.