Speedway Motors Rolling Engine Cradle Stand with Wheels, Fits Chevy V8 Small Block and Big Block, Steel Construction, Built in Hardware Storage, Easy Assembly

Rugged quality. Great welds. Heavy duty to hold my 327. I replaced all bolts with grade 5. Replaced 5/16” crossmember bolts with 3/8”. Probably not necessary for crossmember but did anyway to beef it up. Tip: assemble loosely, attach, then torque bolts. Would recommend to a friend.

Great product at a good Price

I like having the engine cradle and it will hopefully hold up over time. One of the back mounts was not straight and some of the bolt holes did not align just right. The front supports where that connect to the engine mount should have a metal brace welded in like the rear. The 4 bolts that mount the cross brace to the sides are too small (1/4") and I am not sure how well they will hold up. It could be a little better make with only a little effort. It is a shame that Speedway does not fine tune the cradle for better quality that would set them apart fro others.

Easy to assemble, works well, and I love the fact that it comes with the right hardware to mount the engine, and the hardware has a place to be stored when an engine is not in the stand! This stand is holding my BB Chevy without any issues, even with the exhaust manifolds still on the engine.Overall, a great value!

Got this rolling engine cradle for a 1996 454 Chevy. Fits perfectly as long as you assemble it on the engine. Don't build the thing on the garage floor and expect an engine to drop right into it. Put the thing on the engine, all bolts kinda loose. Once you have both sides on the engine, put the cross brace in position. Then just go around and snug everything up ... SHAZAM!! ....all done, fits perfect!The only drawback is, stuff like this is waayyyyy over priced.

It fits my small block chevy 350s and 400s that I have.

I had to loosen one side of this engine mount and whack it with a dead blow hammer to install the block front side engine mount properly. Then everything fit correctly. Its nice that they provide hardware, but the bolts for the cross member seemed a little to small in diameter, so I drilled a little larger and installed grade 8 nuts, bolts and washer.Further if your installing a complete engine on this stand I would recommend American made grade 8 bolts. This stand itself is quite sturdy, so why jeopardies your engine with unknown quality nuts and bolts?

Speedway Motors apologized for the unfortunate incident and promptly shipped another cradle in return. At the end of the day, I was pleased with the quality of parts and customer services from Speedway Motors.