CI100033 Carbon Fiber Intake - 1.8T/2.0T EA888 Gen 3 MQB

Really good quality, if u don’t have a gti mrk 7 tsi 1.8 I have a pussat 1.8 tsi luckily I just have to move my power wire over a little and cut bout an inch and half of plastic and it fits perfect 🕺🏻🚗💨

Looks great, sounds great, easy install. BTW, 16' Golf R.

This was purchased for a MQB TTS - beware that it does not fit flush without cutting some plastic on your car, which is not really acceptable for a $450+ dollar part - it fits and does the job but does not look clean as the pictures display - is actually crooked. To be honest do think this is a problem with Golf/GTI as the front end is a bit different compared to the TTS. However, for all cars, it requires that you remove a trim piece within the engine bay leaving that does not go back on. This leaves the top of the radiator exposed to view in an area not supposed to be seen and looks very unfinished. So bought a nice looking intake but it does not flush (in TTS) and removes factory trim - overall negative purchase.

Installed this on my 2018 GTI w/ APR stage 1 tune. Looks great in the engine bay, easy to install (1hr). Small gains in HP (about 10HP)

Don’t buy this for your Audi S3, doesn’t fit without modifications. For $400+, it should fit like a glove.