Question 1

I  put  1" pvc to find the water table . I found the water bearing sand at 28 ft I was planning on driving a well point and 1 1/4 pipe. What now ?

Accepted Answer

You'll need to purchase a pressure tank that has a platform on top to bolt the pump onto. I used a hard plastic, black-colored pipe to connect both the pump and the tank, using worm screw hose clamps. In total, you'll need ten fittings to put it all together. Make sure you use Teflon tape (about 3 wraps) on each fitting before you tread them on the pump. Once you have all the fittings connected, connect the electrical wires to either a 110 volts outlet or 220 volt outlet (their is a small switch on the motor for either 110v or 220v) with all power turned off while you're working on the connections. Unscrew the small bolt from the top of the pump. Pour water into the pump housing until the housing is filled. Screw the small bolt back in and turn on the power. It may take a few attempts to "prime the pump" before the water starts flowing into your water pipes. If you're not familiar with working with electrical or plumbing fittings, ask a friend who does know or hire a plumber for the job. As an amateur, it took me about 9 hours to replace my old 3/4 hp pump with this new 1 hp pump. Much better water pressure now. Good luck, my friend.

Question 2

Can I cap the jet port and run the pump without the jet?

Accepted Answer

Thank you for contacting us with your question. If the bottom 1" drive line is plugged you will get water but no pressure once it is properly primed. It will also take a long time to prime depending on the depth of the well. We do not recommend the unit to be used this way and we cannot warranty it if fails being used this way. 
Thank you again,
Tina

Question 3

Does this pump come with a deep well injector kit?

Accepted Answer

Thank you for contacting us with your question. Our convertible pumps do not come with the jet assembly. This would be a separate purchase. To decide  which one you need you will need to know the diameter of you well housing and how far you need to go until you reach water.
Thank you again,

Question 4

what is the injector and do I need one for a deep well?

Accepted Answer

You didn't mention the depth, but for deep wells you usually need 2 lines to a foot valve with injector matched to pump and depth of water

Brand	Wayne
Color	Black
Material	Cast Iron
Style	1 HP Upgraded
Product Dimensions	24"L x 12.5"W x 8.75"H
Power Source	Corded Electric
Item Weight	37.5 Pounds
Maximum Flow Rate	588 Gallons Per Minute
Maximum Lifting Height	90 Feet
Voltage	120 Volts
Manufacturer	Wayne
UPC	040066218827
Part Number	56956-WYN2
Item Weight	37.5 pounds
Item model number	CWS100
Size	Upgraded 1 HP
Item Package Quantity	1
Certification	certified frustration-free
Included Components	CWS100 1 HP Convertible Jet Well Pump
Batteries Required?	No
Warranty Description	3 Year Manufacturer Warranty

About Us

Customer Services

Customer Support

Regional Access

Legal & Policies

Social

Get the App

WayneCWS100-1 HP Cast Iron Convertible Jet Well Pump - Up to 588 Gallons Per Hour - Heavy Duty Jet Well Pump

Details

Description

Specifications

Have a Question? See What Others Asked

Common Questions