Rubber Feet Strips Replacement HP Envy X360 Convertible 15.6 Laptop with Stainless Steel Lever and Tweezers (Black)

Got these to replace the rubber strips that I had to remove to upgrade my HP Envy x360 when one of them tore apart when I was removing it. These strips fit well enough (they are a tad bit wider than the one's that were originally on the system -- and just few millimeters longer than the channels for them on the laptop, but a quick trim took care of that.) So far, the adhesive on them seems to be holding well enough. No issues so far.My only complaint is the cost.... these things should run between $3-$5, rather than $11, but then, they are much less costly than what HP originally sold replacements for, so there's that. I suppose I could have gotten along with out these, but I do appreciate my laptop to be no-sliding on a smooth desktop.

I repaired a cheap HP laptop for a friend. And to get at the screws, you have to remove the rubber strips on the bottom of the laptop. Doing this is likely going to destroy the strips and this is about the only option to make the laptop sit still after repair. Plus you get a couple decent tools that you might not already have. These tools are often similar to Fix-it tool kits you see for less than $20 here on Amazon.This hiding screws under flimsy rubber is a horrible thing I have only seen on budget HP laptops so far. Guess they rather you just buy another computer than move the screws over a 1/4 inch. Glad I buy Dell and Asus for my own kit.Also, might have been my mistake, but I was pretty certain I ordered silver/gray. I received black. Anyhow, might be better looking with a silver PC having black feet.

I like that these are slightly thicker than the factory feet so it feels a little sturdier. Very grippy, so it doesn't slide easily.I thought that since I was ordering for a specific laptop, that they would just fit, but they were too long and I had to cut them down more than two inches each. But they still look good and function perfectly. Would buy again if I needed them, but I think these will last the rest of the laptop's life.

The media could not be loaded. These were too short. They're advertised for the 15.6 inch HP Envy x360 but are too short. You can see the screw holes on bother sides. Also, the adhesive came right off when carefully peeling the 3M paper off. Very disappointed.

The feet on my HP Envy were coming off and I found this replacement set. These were very easy to install but they must be universal because they were way too long and I needed to cut off excess. Also, not even a month after installing I have one of the feet flopping off already, so I think I need to purchase some new ones :(

I originally bought one but ended up getting another one for my other daughter14-inch HP laptop. I had to cut a little because this one is for a 15.6-inch laptop. Good quality and strong adhesive, it comes with 2 little tools to remove the old one. I used rubbing alcohol to get rid of the old adhesive left. Good price and great product. Thank you!

It was too wide and too long so I had to get out my exacto knife, which was kind of annoying but fine whatever, but then the sticky backing didn’t even stay stuck to the computer and it started falling off only a couple of days after I got it on! And I even used rubbing alcohol on the laptop before hand to really prep the surface for sticking, and it still didn’t make any difference :/

Perfect size and have been holding on GREAT for over a year!