MySit 3 Inch Rubbermaid Cart Caster Replacement Wheels, Swivel Stem Caster, 7/16" x 1-3/8" Stem TPR Rubber Wheel for Rubbermaid Mop Buckets, Pack of 4

Absolutely PERFECT !!

Castor wheels seem well made and roll easily. Although they do snap in a shopsmith very well, they were not suitable for a Shopsmith MarkV due to brake levers hitting shopsmith base preventing full 360 swivel. Also 3 inch wheel is too tall to utilize standard shopsmith drop down foot lever to the floor for brake/stability. Staying with 2 inch upgraded castors.

Used these to replace the non-rolling/turnable original casters on my Shop-Vac. They come with new nylon inserts that have a slight ridge in five places around the OD which made for a tight fit in the sleeve of the bases. I took my utility knife with a fresh blade and removed the majority of the ridges and they slid right into place. They work like a champ, no more cursing the vacuum since it won't go where you want it to. Recommend and would buy again.

These replacement wheels were a perfect fit for my Rubbermaid mop buckets. The hardware is sturdy and well made. The product is accurately represented by the vendor. Highly recommend!

Had a worn out Craftsmen rolling chair that needed some new wheels. Tried these wheels and the chair is back in service and works better than it did when new. You will have to drill out the original hard rubber inserts that go into the tubular frame of the chair. After removing the original wheels, drill out the hard rubber inserts to be slightly smaller than the white plastic inserts that come with the new wheels (I removed the hard rubber inserts and placed them in a vise to drill them out). Note: These will not work on the 51108 seat without drilling out the original hard rubber inserts. Check to make sure the original inserts are in decent shape before ordering. As for other Craftsmen rolling chair models, I'm not sure if these will work or not.

After years in my garage, which gets pretty warm/hot, especially during the summer months, here in Hawaii, the rubber wheels on my Weber grill started shedding pieces.A search for replacement wheels turned up really expensive oem wheels from the manufacturer.Bought these wheels after reading other reviews. I can confirm that they fit on my older Weber Genesis stainless steel three burner grill (controls on the side, not in the front).I'm confident that these smooth rolling wheels will outlast the original wheels. As mentioned, none of the wheels have a locking lever. It's never been a problem for me me, as I grill on the back patio with a textured cement surface. If the grill rolls around too much, I'll just chock the wheels with some scrap pieces of wood, or make more elegant wheel chocks when I have the time.Like others, I wish I had replaced the original wheels sooner. These hard rubber wheels are much better.

Received the wheels and realized you need a 15mm drill bit (5/8” should work as well) if installing into wood in order to install the nylon insert. Besides that, the wheels are a great value. Remember, no brakes/wheel locks on this product.

Needed to replace caster on a weber genesis grill (2011 model 300). The stems on the casters were identical to the stems on the original caster and were the same 3" diameter wheel. The one downside for some will be the lack of wheel locks because none of the casters came so equipped. Was not a factor for me. Simply popped the old casters out and in just a few minutes the job was done-just had to shove the new casters into the already existing mounting blocks for the original casters.