TIMING BELT KIT with Water Pump, Tensioner, Idler Pulley, Seals | Compatible with TL, MDX, RL, ACCORD, ODYSSEY, RIDGLINE, PILOT ZDX V6 | Complete Genuine Aisin OEM Kit

The Honda timing belt and water pump kit fit perfectly on my 2007 Honda Pilot. Much to difficult for me to install at my age so I had it installed by Honda and the service tech stated “ everything fit like a glove”… Actually it should have because it was all Honda OEM parts. Price from Amazon was 50% less than from a certain Honda dealership which made it an excellent value.

Did my 2011 MDX timing belt, It's quite a bit of work so I wanted quality components and these are.

These appear to be Honda OEM supplied parts. We did the job in about 5 hours this weekend.Notes: All parts, including bando drive belt fit my particular 3.5l model engine. Others had said that the drive belt was too small i had no problem.I had to purchase a 19mm Lyle Harmonic Balancer socket $26 and Milwaukee High torque 1/2" drive impact kit for $350 (links below) to remove crank bolt and complete this job. OEM blue coolant and Honda power steering fluid the job cost me $740 to do it myself and know it was done correctly.Milwaukee 1/2" impact https://www.amazon.com/Milwaukee-2767-20-Torque-48-11-1850-Battery/dp/B081NX1LTQ/ref=sr_1_5?crid=1SR2ST4LVP90V&dchild=1&keywords=milwaukee+high+torque+1%2F2+impact+wrench&qid=1626717976&sprefix=milwaukee+high%2Caps%2C220&sr=8-5Lyle 19mm harmonic balance remover: https://www.amazon.com/gp/product/B00RGNCV1U/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

Everything is what it says it is in the package.

All components fit perfectly on 2005 Honda Odyssey. Unlike other post stating Bondo drive belt too short. I thought so at first, but triple check the belt seating, you'll find it's not seated correctly in one of the pulley groves.I used the Lisle 58430 Shaft Type Seal Puller which made the removal easy. The rear camshaft seal was the most restricted access, but the tool popped it right out.The crankshaft pulley bolt is a pain. I needed the special tool to hold the pulley while loosening the 19mm bolt (argh!). None of the impact wrenches worked. Used 24" of 1/2" extensions supported on a jack stand outside the wheel well while using a breaker bar with 36" pipe cheater.Special tool, two breaker bars, 20 - 24" extensions, cheater pipe.

Me encantó original

Because fitting perfect

Made for flawless installation