12V Portable Diesel Heater, 6L Fuel Tank Toolbox 2 Diesel Air Heater 8KW All-in-One Parking Heater, Car Heater with Bluetooth APP Control for Car Trucks RV Motor-Homes and camper

It’s only a 2kw heater and perfect for heating my roof tent!Just added some aluminium ducting and used the remote.Toasty!

Conveiniant good heater. Just have to be carful as bottom gets super hot, legs should be higher

Works faultlessly, a great app for control

Relay happy works well a bit mosey but the are all the same..

Dose not perform noticeably better than two other diesel heaters I own which cost less than half the price of this product. It has 10 heat settings, number1 giving out less heat than number1 on the 6 heat setting models, I assume that the pump Hz setting is a lower value which allows the 50 plus-hour run time on low to be made as it it uses less fuel but gives out less heat therefore it is not a true comparison, that and the 6 litre tank compared to 5 litre. Also using the supplied controller as reference it it gives out no more heat than my other heaters. Be aware that nowhere in the supplied manual or on the box does it say it is a 8kw heater only the Amazon listing says that. At the moment it is out of action as it is smelling of diesel in the room the air is being pumped into and I need to investigate why.In conclusion I think this product is more of a marketing exercise than possessing any meaningful improvements over other similar cheaper products.

Now all I can say is this heater is amazing so good no need for anything else

Everything that was identified was in the box, but quite a few additional parts still required to be purchased to complete the installation/ build requirement. No fused system to support UK electrical safety, the heat out nozzle would benefit from being 10-15mm longer to accommodate the heater hose jubilee fitting; apart from above the unit started up and performed as promoted.

The media could not be loaded. I have used this for heating a large garage that is attached to my house. The inside temperature was 13c when I first started to run the unit. After 1 hour at maximum output it was 24.7c and I have been able to maintain a comfortable temperature with ease.I simply bored a small hole in a ventilation block for the exhaust and used silicone to seal the remaining holes to prevent exhaust fumes coming in.Would recommend.