Trail Rail System Truck Bed Tie Down Rail Compatible with 2020-2024 Jeep Gladiator Replace# 82215956

I am happy with the rail system. It fit my 2024 Jeep gladiator perfectly! I was nervous because it was only listed up to a 2023. I took the advice from prior reviews and used a tap on all of the holes. It was installed in about 15 minutes and was a great base for the our MOLLE panels and truck rack. Very happy with this product!

Excellent quality. Very sturdy. Can't imagine that the factory ones are any better at more than triple the cost. If you have a spray in bed liner you will need to get a thread chaser to clean out the threads before installing. Works great with the Tyger roll up bed cover and the tacmolle bed molle panels.

At a fraction of the cost of the Mopar cargo rails, I figured these were worth a try. The box came with some tape cut and re-taped but all the pieces were still present and the rails in good condition. During the install, there are four screws labelled "F" shown to attach the front rail to the bed. Looking at the part list on the first page of the instructions, there is not a "F" bolt shown. I counted the "D" bolts and there were enough for all the holes and used those instead. On the next step, it showed an arrow pointing FWD supposedly indicating the front of the truck however it was pointing to the rear of the truck. Honestly, it was pretty easy to figure out that their instructions were not correct and I was able to finish installing the rest of the rails.Overall I think these are pretty good. I have a tonneau cover on the bed of my truck so they won't be exposed to direct weather so I expect them to hold up well. I did use a tap to clear the factory bed liner from the screw holes so I didn't have any issues getting the bolts in like some of the other reviews had stated.

Very easy to install on my 2020 jeep gladiator. I did have to use a 6mm tap to clean out the holes in the bed but after they were cleaned, everything fit like a glove!

Does it work, yes. However, if your bed has the factory spray in liner it is very difficult to get the supplied screws started. After stripping one of the supplied screws, I got a higher quality bolt of the same size and cleared the threads in the bed. The rails fit but the mounting hardware leaves a lot to be desired. It is also much more difficult to mount a bed cover over the rails.

Works great and so much cheaper than the factory version. Highly recommend and looks great in the truck.

So if you have the factory spray in bed liner you’ll need to clean the bolt hole threads with a tap, other reviews have the tap size. then the bolts will go right in like they should the instructions are not hard to follow just ignore the photos in the instructions. They are just as nice as the factory ones and as sturdy

Work great and look great on my 2021 Gladiator Mojave. Like others have said if you have a spray in bed liner you will have to tap the holes which was very easy. A tap set at Lowe's was $14.