Reusable Full Face Cover Dust Gas Face Cover with 10 Replaceable Filter Cotton and 5 Pairs of Gloves, for Organic Vapor, Chemical, Petroleum, Dust, Paint
M**R
Great product
Great product, doesnt fog, easy to set up and adjust
M**K
Brilliant eye and dust protection at a good price
The best mask I have bought in a few years. For this price I was a bit sceptical but I highly recommend this. I can wear this with glasses but more comfortable with out. After two hours with it on my breath finally produced water inside which steamed it up but shorter periods it was fine. This is easy to fit by pushing the rubber bit around your nose and mouth and pulling both straps to tighten. So easy to remove using the release tabs. I bought this for fitting Kingspan in my workshop garden room and it protected me from the fine dust very well. I can’t comment on the ability to protect me from paint fumes. Would definitely buy this again
P**M
Value, effectiveness
Good mask, seals ok, bit tricky with glasses, but manageable. Protection seems fine on dusty work
S**R
Good fit and works well
Used the mask to apply waterproofer to a concrete screed comfortable to wear good protection and visibility
R**C
Fitted well
Fitted my grandson well. Has already protected him from vapours and droplets from trying out spray painting. He fitted it on easily himself. He’s 14 but taller than me. Young but adult sized already. I think this will still fit him as he continues to grow. I now have one for myself also. ( I want a go - but it was definitely ‘fumey’ )Putting it together was easy but you do need to follow the instructions. Fixing the filters to the main body of the mask you need to be firm and the twist to lock in place is outwards towards the edge of the mask, so a different direction for each side. - From the front your right hand side twists clockwise, your left hand side turns anti clockwise. They push into place positively. They have shaped fitting, line it up so it sits almost upright, push in then it turns and ends up at an outward angle. They twist back out again to allow changing the filters so if it doesn’t look right undo and try again.The straps he found easier to get even with help but they pull through easily and stay in place well. He left the top two as they were and eased the bottom two loose to remove it. You need to get it at the right angle.He was getting quite sweaty towards the end, it was hot that day, but he did not seem to have any issues seeing. No fogging. Cannot vouch for all day use as was an afternoon from about midday.
P**L
Low optical quality
The facemask is decent for the price, the rubber seal sits well on the face and respiration is well protected. However clear plastic visor has low optical quality and gives distorted vision. It would not be advisable to wear for any long periods.
J**R
Mask
Great product & a good price
N**R
Not suitable for spectacle wearers
I bought this mask a week ago as they seemed good value. I usually wear a separate googles / mask combo but these still let in dust so I thought it was worth giving the one piece a try.I tried using them for a job that did not require spectacles and they seemed fine and did not fog up. I then tried them for a task that required work where I would need my specs. I couldn’t put the mask on while I wore the specs and nearly wrecked them. I next put the specs into the goggles and tried to carefully pull the mask on and managed it with some difficulty. The specs were now in front of the mask element and against the visor and so were an inch from my face but my vision was still ok at that distance. On the other hand the legs of the specs were not a very good fit on my ears and the rubber seal around the mask could not make the seal with my face because the legs forced the seal away from my face, thus defeating the main reason for wearing the mask. I then tried to pack the mask away in the complimentary storage bag only to find that what I thought was a cloth bag was only made of black paper and it fell apart in my hands.I was disappointed but you only get what you pay for. I would return the mask if I hadn’t already used them in my first task. I may try drilling two tiny holes in the seal to allow the spec legs to pass through to see if that solves my problem. I don’t know how professional masks solve this problem but this mask does not provide a solution.Buyers beware.
ترست بايلوت
منذ شهر
منذ شهرين