INJORA313/324mm Wheelbase Chassis Kit LCG Carbon Fiber Frame Girder for 1/10 RC Crawler TRX4 Upgrade Parts

Highly recommend this chasis. Doesn’t have instructions but super easy to figure out and TONS of people online with great info! Already ordered another for my sons rig

I found a video that someone built one and I was looking to build a comp style crawler. If you have spare parts or just want a comp crawler that’s not going to be very expensive, I recommend purchasing this chassis kit and having fun for less money.

The only redeeming quality this kit has is that it is cheap. If you value your time, look elsewhere.My expectations were low going into this, but INJORA went lower.-Missing M3 nuts-Front end will bind hard with the included rod ends. Need to use the angled ones from the stock truck on the upper link. And even then it will require playing with link lengths to tune out all of the binding.-Rear end will bind hard with the included rod ends. Need to use the angled ones from the stock truck on the 2 upper links.-Rear link lengths are way off. Had to mix and match the 324 and 313 links to get a functional pinion angle.-Drive shafts work ok if you swap them front and back. Not the best, but it's passable.-The pinion is half hanging off the motor shaft in order to line up with the spur.-They could have pushed the transmission forward and fixed the above 2 issues. There is plenty of room for it. At most this would require an extra hole in the motor plate for clearance on the spur gear nut.-Doesn't come with a servo mount, stock servo mount doesn't work either. So you either need to make your own or spend more money and buy one from them.-Rod ends are super low quality. Some of the hollow balls are too tight and some are too loose.-Hardware isn't organized well at all. Sometimes the screws you need are in the same bag as the part, and sometimes they are in a separate bag with a completely unrelated part.-ZERO INSTRUCTIONS. Not even an attempt was made to send you on the right path of putting this thing together. Even just an exploded view with the bolt lengths would have been a huge time saver.

This kit rocks!!! The trx4 is a good crawler out of the box, but this kit turns it into beast mode. Everything is top quality and the carbon fiber is also good quality. The assembly is straight forward for a hobbyist. The trx4 stock is good for bashing though, so if you want to bash then this kit is not for you. If you want to climb Everest then this is the kit!

I think this will be a great upgrade to my rc crawler. Only problem i have with it so far is there is no instructions on how it goes together. For just getting into crawling and tires was recommended to me. There should come with assembly instructions just in case your like me and fumble your way through it. Product looks clean. Build quality is great. Just needs a little more to be desired on completion of product. Internet is also not really helpful in getting it all together.

Seems to work pretty well. No instructions so that was a task but fun to figure it all out. You should go ahead and throw away all the screws it comes with and use better ones. You will end up striping all the heads. Carbon Chassis pieces are well made as well. The body mounts also wont line up with scock body hole, so keep that in mind. Definitely not a easy upgrade but definitely worth it.

I bought this for a budget build for my Trx 4 1/10 scale truck. I transfered all my parts over to this Chassis. My son has a custom comp build, cost him a lot of money. After I replaced my motor with a great motor that has the Esc built in, and is brushless, my truck crawls everything his does. And for a fraction of the money.

Excelente chasis