Replaces for GM Transmission Shifter Lever Seal Remover Installer Compatible with GM Turbo 300 350 400 425 475 700-R4 4L60 Includes Seal

Great product. Fast shipping!

Would not fit over shaft had to machine the ID of the tool , tool would not grab seal without extreme force applied , the seal that came with the tool had wrong OD and would not stay in transmission Case had to order a CR seal that fit and stayed in case Atleast I only gave away a fee of my hard earned dollars

Worked great for my 79 camaro. I was struggling to get it to bite at first. I tapped it lightly with a hammer and still nothing. I then grabbed a pry bar and place it between this tool and the car floor pan. Applying pressure while I tightened it with a ratcheting wrench. That did the trick on the first try. Installation tool worked great too.

Getting a good one is hit and miss. First one just crumbled when it was screwed in.The second one needed the inside opening opened up a little to fit over the shift shaft.I have a die grinder with burr bits so it was no biggie to clean up this area.This time it worked perfectly.There’s not much else out there to choose from .If you have one shot to pull a seal, buy two and return one.

Perfect tool to remove seal witout have to remove shifter shaft. A must have tool.

Use this tool on a turbo 400 transmission and worked perfect for removing the shift lever seal and came with a new one which was nice

I wanted to listen to the reviews and not buy this but there are hardly any options for this tool and nowhere to get it except online. It was not wide enough to make it down to the seal.I planned on being careful with it from the reviews about breaking but couldn’t even get that far.

It worked after I took a 1/2 drill bit to shave off some material from the center cause it wouldn’t clear the shaft due to the coating.