Auto Ventshade [AVS] Bugflector II Hood Shield / Protector | Fits 2008 - 2013 Ford Econoline Vans, 2008 - 2025 Ford E - 450 Super Duty | High Profile Bug Deflector - 1 pc., Dark Smoke | 25016

Super easy install. looks and fits perfect on my 2009 Ford E-350 van. If your hood doesn’t close after the install, remember to adjust up or down on the 2 huge rubber hood stop screws on each side of the front of the engine compartment that determine the height of the hood when latched a couple turns up or down will do the trick. Great seller too.

Fits "nearly" perfect.In general this fits 100% but I did elongate the holes side to side to give me a little adjustment room.My driver side was a little tight to the headlight edge so I could move it toward the passenger side a little to gain room, and it was perfect.Well made great item for our 2018 dynamax isata4 31ds, ford E450 chassis.

Works great. The self tapping screws are worthless. Had to predrill holes then use the screws provided. No big deal . I would buy again.

I installed this in my 2008 E450SD shuttle bus conversion and it fit perfectly. It looks great and protects my hood and windshield, Good buy, AVS has always been my choice for my other vehicles as well. I purchased the matching widow ventshades here https://amzn.to/4ddkvTx and they work perfect together.

One of the reviews said it took his mechanics a short time to mount. Took me about an hour in 87 degree heat. Good thing I had tools from removing a door panel to remove the plastic clips holding the rubber gasket on the bottom side of the hood. Only had to drill 2 very small holes on the underside of the hood to secure the plastic hood at both ends. Looks very good once mounted, hope it keeps bugs and rocks from my windshield for upcoming trip.

Cumple con lo prometido es un producto muy bueno y fuerte muy fácil de instalar

This product installs just as outlined in the instructions, in about 15 minutes. The 4 large screws self-tap into the existing plastic plug holes, in the center of the hood, where the weather strip is mounted. My only issue with installation was that the smaller "self-tapping" screws on each outer end, did not self-tap. My attempts to self-tap resulted in the screws being worn dull at the tips. While I had to drill a small holes, in order to start the two small screws, dropping a star for something so minor would be disingenuous. I touched up about 30 paint chip spots before installing, so this will be well worth its price. Save the rubber bumpers that get adhered to the hood for the extreme ends. The deflector is sturdy enough, I don't anticipate hood contact in the middle area.

I accidentally ordered two of these - and they both came so promptly that I found a use for the second as soon as I had the first one on my Ford E200 van. This deflector fit well with no problems. It also has lasted through the last year and several trips around the country at speeds I won't write down because that would constitute evidence. I put this deflector on when I was also installing a solar panel on my roof; so I found a use for the second deflector by putting in on my desktop sander and sculpting it to fit the top of my van. Now it deflects the flow of air up and over the solar panel, resulting in less drag and no decrease in miles-per-gallon. Good product with no problems.