Red Oak Wood Veneer Edgebanding Preglued 3/4" X 250' Roll

I have used lots of edge banding in my 55 years of woodworking and this is the best and the least expensive. It is just barely wide enough to cover 23/32 plywood, which means very little trimming. It is so thin, I can cut it with scissors. Nice! Once glued down, the thinness does not matter. It is still thicker than the crummy veneer that comes on plywood these days.

This is a great product if you use edge banding. I've used other brands brom home improvement stores and the glue was just not as good nor was the quality of the wood veneer. I would recommend this to anyone who uses edge banding.

This edge banding is good but if you sheet good is a little thicker that 3/4 of an inch it won't work because it's exactly 18 mm. And it's too smooth so it won't match the wood if you are to stain it. Other than that very usable

Applied a whole lot of this today on a murphy bed project. So far it has gone on without a hitch and seems to stick just fine. Based on today's experience, I'd buy it again without reservation. Plus it's made in the USA.

These are perfect and cost effective than the ones I used to by at HD or Lowes. Fits well on the 3/4" plywood and sand of excess. No need to strip off the excess .

I was a little leary of using edge banding before but after using this product I would use it again.

The bandied is a little thinner than a batch I finished so care needs to be taken when finish sanding. In some areas the adhesive was applied too thickly and oozed. I didn’t run into thin spots. The surface was a little rough so it has to be sanded, but as I said above it is a thinner gauge than other iterations of the same product.

Arrived on time and help me finish project on time and under budget. The banding worked as advertised and looks great finished.