TORQUE Airbag Air Bag Suspension Kit compatible with 2007-2021 Toyota Tundra 2WD 4WD Rear Helper Bag Spring Towing 5000 lbs (Replaces Firestone Ride Rite 2445) (TR2445)

So I had one of my bump stops already missing and the other one was about to fall off anyways so I ripped it off, this made my decision much easier since these needed to be cut off anyways and I tow a 28' camper. Install was very easy but as you can see in 1st 2 pics our fuel regulator actually has 2 bolts and kit only comes with 1 but thier instructions state X2 for PCS. Contacted them and I believe they are sending 1 to me because I told them the regulator is a bit shaky with only 1 mount. I decided to put a T in so both bags are at same pressure all the time and I just ordered a Bluetooth TPM cap which are for motorcycles but will work jus fine. I gave 4 stars for now because of the missing part and also the valve stem itself is very hard to get nozzle on and off and you lose pressure fast. I ordered an inline shutoff valve which was like $8 that will help out with that. Not going to go compressor system because I found a nice little rechargeable, hand held unit that will work great not jus for the bags but all my tires too. Nice kit though, bags seem to be of nice quality but only time will tell on all the hardware especially top plates which are pretty thin and the carriage bolts when it comes to rust issues. I plan on spraying everything with rubber coating or bed liner spray. Installed on 07 Toyota Tundra 5.7L TRD CrewmaxUpdate: contacted them about the missing fuel pressure unit missing one of the 2 brackets and they sent me all new brackets so I got and extra set of everything so TY for that. Also installed a motorcycle TPM valve cap that runs off my phone so I can keep tabs of bag pressure.... Works great!! I'm gonna give em 5 stars now. 😊

I bought the kit for my 2007 Toyota Tundra and discovered a few pieces were missing from the kit (one of the fuel control module brackets, both of the large nuts that attach the top of the airbag through the frame, and a few washers). I called Torque and explained the problem, and they immediately shipped the second bracket and a whole new set of all the nuts, bolts, washers, etc. I got it in two days! While the kit not being packed correctly was a disappointment, their great customer service made up for it.Installation was easy, and here's a tip nobody mentions on YouTube: when you cut out the old bump stops from the top of the leaf spring assembly, cut it below the level of the U- brackets but not all the way down to the leaf spring itself, you will end up hitting the nut centered on top of the leaf springs beneath the bump stop.The kit fit perfectly and the brackets for the fuel pump control module gave the perfect amount of clearance. Get the brass air nozzles on top of the airbag snug, then add another 1/4 to 1/2 turn. Make sure you cut the air line square and press into the nozzle until you hit the end, then give a gentle tug to make sure it's seated correctly.I have no leaks and the kit makes a dramatic difference (you can put your truck's butt way up in the air if that's your thing). A little air goes a long way in how it affects your ride - you will feel the difference and get the correct PSI worked out for your truck.The kit makes a nice difference in how your truck rides when it's empty and I use it along with my weight distribution hitch when I pull our trailer. It's a great product at a good price!

Awesome product. Very easy installation,no drilling. Took about 45 minutes. I drove 7hours with a camper both ways with great ride and zero issues

The install went well and the kit provides everything you will need. It even comes with the cutter for the air line. When you open the instructions on the very first page there is a warning to not lift the vehicle from the frame and that over extending the bag could cause failure and would not be cover by warranty. Obviously I had questions so I contacted them and asked how was I to have my vehicle serviced if the garage puts the truck on a lift and the rear suspension hangs. The response was not very reassuring and they said it should be OK. I had to buy a set of air bag cradles that you can see in the pictures.

Well made. Relatively easy to install. Works as it should. Definitely makes towing our camper safer and easier.

Bought this product and it worked well for a short period but it lost pressure within a few days. It will not stay aired up. Also just recently I noticed that the metal ring around the middle of one of the airbags has broken. It lasted about a year. So my advice, look for a better made product.

Great product, fit and work perfect.

Install was very easy. The hardest part was the relocation of the fuel module. I did have an air leak, but figured out what the problem was. The fittings that connect to the top of the bags had a little bit of thread locker to seal them(I think). I removed and added Teflon tape to the threads and now it is holding air. I like a stiffer ride so it doesn't bother me that bumps are a little harder when driving over. Haven't had a chance to tow yet, but will update when that happens. Also, I added a tee to the system so both bags inflate at the same time and only needed one ripple for air.