Edge Supply Birch 2" X 25' Roll, Wood Veneer Edge Banding Preglued, Iron on with Hot Melt Adhesive, Flexible Wood Tape Sanded to Perfection. Easy Application, Made in USA

Edged some cabinet doors and found this product very nice to work with. I only have a regular laundry type iron to heat the strip, but it worked perfectly. One pass at about 10 seconds per foot, at the high-heat setting, seems just right to get the correct heat for adhesion. This would of course depend on the heat power and size of the iron you're using.

Used on a cedar chest restoration project. Ironed on without an issue. My project turned out awesome.

Just irons on, it's that easy. I'm only going with 4 stars because there is a seam every 3 or 4 feet that doesn't look that great. Other then that, the glue works very well and stays on.

I had just built a new computer desk; but, I was happy with some of the unfinished ends and edges on parts with open cuts on the wood. After using a narrower veneer for the desktop front edge, I needed to find a wider veneer to cover up the ends of the drawer supports where I had stacked two pieces of wood. This 2" roll was perfect, and not exactly easy to find in any local home store or hardware store; so, thank you Amazon as always!All I needed to do was cut the pieces need, uae a typical house iron (I set mine on the cotton setting with no steam), press down and iron the piece in place, let it cool, trim off the excess with a sharp blade, sand the edges, and put a couple coats of poly acrylic on itso it matched the rest of the desk and protected the wood, and VOILA! I much nicer and finished looking desk. I only had to use three 3" pieces from the 25' roll; but, it was worth it, and now I am ready to finish future projects.

This birch edge banding is size perfectly, and is of excellent quality. The hot blew backing adhered flawlessly. I used it to conceal the plywood edges on a set of cornhole boards. It worked perfectly.

Product impeccably made. Glue was evenly distributed on the back to allow for great contact when iron was applied. First time using edge banding and was really impressed with this product. Sands really well by the way and takes paint well.

If you're familiar with using edge banding than you probably only care about two things. The finish and adhesion quality. This product provided both. The color was consistent without too much variation, and the banding adhered well to the plywood edge it was applied to. I do not use banding this wide very often so my only mistake was me not assuring heat was applied evenly across the entire surface in some spots. Especially on curved sections, so after the first coat of primer was applied I did have a few bubbles where the glue did not get enough heat. A razor knife and Bondo quickly fixed that.I would definitely buy again.

It's oak match my ply great but I hate where they connect you can see it more when you apply varnish.