Edge Supply Birch 3/4 in x 50 ft Roll – Pre-Glued Iron On Wood Veneer Tape – Wood Veneer Edge Banding Tape with Hot Melt Adhesive, Smooth Sanded Finish Ideal for Furniture & DIY, Made in USA

I couldn’t be happier with this 1 inch iron on edge banding. I used it on poplar plywood from Home Depot and it matched perfectly in both color and grain. It gives a clean, finished look that makes the project appear professionally done without the hassle of adding solid wood edging.Application was quick and straightforward. A regular household iron was all I needed. Just align it, press it on, and you’re done. It bonded smoothly with no bubbling or peeling. This product saved me a lot of time and was much easier than milling and attaching hardwood strips.A helpful tip for anyone working with three quarter inch plywood: make sure to buy the 1 inch width. It gives you a little overlap on both sides that you can easily trim off with a utility knife or edge trimmer. That extra bit of width really helps get a flush, clean edge.It also takes stain, paint, and polyurethane beautifully. No blotching or uneven spots. The finish looks smooth and consistent with the rest of the plywood.If you are working with poplar plywood and want an easy and professional looking edge solution, this is absolutely the way to go. Highly recommended!

The Edge Supply Birch 2” x 25’ roll is a high-quality wood veneer edge banding that’s easy to apply with a household iron. The pre-glued hot melt adhesive bonds well, and the flexible, sanded surface ensures a clean, smooth finish. Perfect for raw edge floating shelves or DIY furniture projects

This edge banding seems to work great. Ironed on perfectly. time will tell if it stays on

I used several different brands and the quality of this banding was quite nice. It didn't have many splices in the material, I believe I found only 3 over 50ft, and the splices that were there were done well. I typically don't use spliced areas, but these were usable in a pinch. I've seen similar products where the finger-joint splices are just horrible. The only downside was its width was barely 3/4" so it was a tight fit on the birch ply I was using. Still plenty usable, just had to be careful on placement. I'd purchase 7/8"-wide next time.

I purchased this edge banding to make “siding” for a wooden dollhouse. I overlapped each strip and temporarily glued them in place. Then I used my regular clothes iron to heat the strips. It worked perfect and resembled real weatherboard once painted. The house was not too big and I needed two of the rolls with maybe 6-8 feet left over. I did not notice any joints in either of the two rolls. While I did not use this as edge binding, it did serve my purpose and I would recommend it to anyone wanting to use it for dollhouse siding. Also, the quality was quite nice.

Excellent edge banding. Have ordered from this supplier previously. Very pleased with this product.

Works great. Just as it should.

Worked as it was suppose to.