EIGIIS Car Hood Vent Scoop Kit Universal Cold Air Flow Intake Fitment Louvers Cooling Intakes Auto Hoods Vents Bonnet Cover (Black Plain)

Absolutely Perfect !!! These are frigging awesome !!! There solid ABS Molded plastic, with little flex. They are a great gloss black and come with ultra thin 3m two sided tape. Just make sure you clean the vent flange and the place were you'll be applying the vent to really good with 70% or better alcohol. I'd personally use the 3m primer, that tape will never come off !! So I installed these on my turbo Kia Optima to get the heat out of the engine compartment on the left side and to allow the intake to breathe cool air on the right side. I made a template from the box it came in then I measure and taped off the area , took a 1/4 drill bit and drill the corners of the taped area. I used a Bosche jig saw with 21t long blade and cut through the hood and inner metal and insulator. Test fitted it, then cleaned the area real good with alcohol and applied both vents. The amount of heat that exists is crazy, my under hood temps dropped almost 20' degrees and my intake is sucking cooler air now which in turn makes my turbo produce more power.Love these highly recommend they look great and easy to install.

Looks amazing when you take your time and line everything up. Its about the same size and look as the stock mustang GT vents. I recommend removing the hood liner and sitting that on the engine while just lowering the hood and not fully latching it to prevent making a mess with the metal shards in the engine bay area. Also remember to remove any kind of hoses from the washer fluid as well that may be attached to the hood.

They are nice and they form well to contours of hoods. They get scuffed easily though so be careful.

Good value, good quality. The finish was better than I expected. Since ABS isnt the best material to use in high heat, these would properly be fine to use as a decorative vent on your typical stock daily driven V6 or V8. If you are looking for a functional heat vent for a track driven 700+ HP supercharged V8, you are better off with fiberglass or carbon fiber.

This product is a good deal and is decorative and relatively easy to install.

Looks nice and seems like it would be functional. But, too thin to trust cutting my hood. Longevity will definitely be an issue.

I’d say these are 4x to expensive, made from cheap material and look cheap.

Helped drop my intake air temp. I'd recommend using some other adhesive to stick one. The double sided tape it comes with isnt all that great. For install I'd recommend looking at some YouTube videos.