HI-FLO Spout with Reducer Tip & Vent Kit (2 Pack) | Fits 1-3/4" Openings | Compatible With All EZ-POUR Adapters | Reducer Fits Older Tanks, Water Jugs, and Industrial Containers | Replacement Spout Kit (60060AZ)

This is my second order of these spouts. They are awesome! I fill my tractor with a 5 gal can and the original spout took forever with a full can. And the fill cap is about 4 feet up on my tractor. The HI-FLO gets the job done in about 30 seconds.

This kit is good for 2 containers, so you can replace the awful "safety" ones that leak and flow super slowly. There are two thread styles, so they will fit on most containers snugly. One is black and the other is the yellow one. The kit comes with vent plugs that install really easily. DO NOT overdo/ream the 1/2" hole drilling, or it will be very loose and leak. You will want to add the smaller nozzle for filling things like chainsaws, weed whackers, and push mowers. The gas flows out really fast! Super easy to install and use.

These are great add-on for those useless so called “green vapo-lock” fillers that take four hands to work, then leak; on those overpriced $40+ fuel cans. Back to simple and safe. Be careful where you drill the vent.

spouts were good except that one of the large spouts was missing its gasket. I contacted the seller and am waiting for the part.

I picked up several gas cans to fill in case of emergency (storms, etc.). They all had those red spring loaded vents on the pour spout. I can not get the vent to pour gasoline, as it needs to be held while holding a full can of gas. The EZ pour fit the can, and the vent installed in seconds. The instructions recommend not using a twist bit in order to cut a cleaner hole, so I used a 1/2 inch spade bit and went slowly with it. I followed a recommendation I saw to not drill the vent hole on the tank seam, as it can lead to splitting. The vent plug snapped in, and the can now works like it should.

I am very happy with the EZ-POUR HI-FLO spout! I finally reached my breaking point. After years of spilling gas trying to manipulate the frustrating EPA mandated “safety nozzle”, I finally purchased the EZ-POUR nozzle and boy howdy, I wish I would’ve done it years ago! The nozzles comes with everything you need and fit my gas can perfectly. The nozzle cap is screw on with a zip tie retainer so you don’t lose it. It also comes with a vent that makes, dare I say, pouring gas into my lawnmower a pleasure!!! Look ma, no gas on my hands! I really cannot think of any way this product could be improved. Buy it. Buy a couple of them. Buy some for your family and friends. They makes great stocking stuffers. You will not regret your purchase.

These are awesome, I have them on all my gas cans. The flow rate is four times what the "safety" spouts do which is a huge benefit when you're pouring 5 gallons into a UTV, tractor or zero turn mower. They seal well enough to travel to and from the gas station with no leaks. My oldest pair is over 5 years old with no signs of breaking down.

These work great and are simple to use.

Great, avoids spills

I had to use the original black cap that came with the can in order to use the EZ-Pour spout, neither of the yellow caps worked with my Canadian tire bought gas cans. overall I have zero regrets, highly recommended.