MidTen2MOA Red Dot Sight 1x25mm Reflex Sight Waterproof & Shockproof & Fog-Proof Red Dot Scope with 1 inch Riser Mount

Great product and easy to install.Sights are clear and works well

High quality red dot sight for a great price! I needed a sight for my airsoft gun, and this did the job perfectly. A lot of times when you purchase a set of sights it is usually too close to the rail to peer through it, but luckily this product comes with a riser that lifts it to the perfect height!I've run with this scope a few times on the field and its durability is incredible too. It's been hit quite a few times by opposing fire and not a scratch or crack in the lenses.I also like how efficient the battery life is. It takes a coin battery, but it lasts for hours, and the best part is that the power of the red dot is adjustable so it's perfect for whatever your conditions are.Overall a 10/10 recommend!

Works well for cost. Short range. 10–15 yards

As far as for use on a paint or pepper ball weapon this is absolutely great! I don’t knowif I would use it on any other type of weapon. Once again it works great on a low to no recoil weapon.

This is a very nice red dot sight with 11 brightness settings. Zeroed the sight with a 5.56 bore sighter and it has held 0 for over 300 shots from my AR-15 and hits 0 at 100 yards.I strongly recommend this optic for 1) the durability 2) the price and 3) it stays on 0

First I have to say that this red dot is actually pretty good quality for the price. I have it mounted on my edc rifle. After sighting it in it seems to stay on point for every shot. Especially after bumping around in my truck. My only complaint with this sight is that it does not cowitness at all with iron or magpul sights. I’ve tried it on both and the sight mount is too high to cowitness. Overall is is a good sight if you aren’t planning on keeping your irons or magpul sights on.

Seems to be OK for now as I have not used it at the range yet. If it has an issue I will come back and adjust this review. It appears to be as described and mounted just fine.

I am going to compare this sight to the Bushnell TRS 25 because I bought this one as an alternative to it. And at first glance it seemed like the perfect alternative, but it has numerous shortcomings. I know that the TRS 25 is not the greatest red dot out there but it definitely is a great bang for your buck, and is well made regardless of price. I think it is a good baseline red dot for under or around $50 (they have been as cheap as $25 after rebates)General: The Mid Ten sight is well Built, has a good finish, clear glass, and comes with a riser. This 3 slot picatinny Riser seems to be of really good quality, lightweight, skeletonized, and has a rectangular locating tab on the underside, which results in a very good fit a rail. It has allen screws and is NOT quick detach. It is a 1 inch riser, so will NOT absolute co witness the sight to standard magpul BUIS if mounted on a 1911 picatinny rail. I think it will LOWER 1/3 co witness. If you want absolute co witness, you need .83 inch riser (UTG maks an excellent mount).Coparisson:Bushnell TRS dimensions are as follows:Overall Length 62 mm;Visible (actual transparent glass area) ocular lens diameter: 17 mm;Ocular lens tube diameter (the housing surrounding the ocular lens) : 28 mm;Visible (actual transparent glass area) objective lens diameter: 23 mm;Objective lens tube (housing) diameter: 28 mm;Dimmer knob (rotating switch)diameter: 30 mm.MidTen dimensions are:Length 69.3 mm; (Longer than Bushnell TRS 25 - results in tunnel vision narrow field of view)visible ocular lens dia 16 mm; (narrower lens)ocular lens tube dia 28 mm;visible objective lens dia 20 mm; (narrower lens)objective lens tube dia 28 mm;dimmer knob dia 29 mm. (slightly smaller)The longer length and smaller diameters of both ocular and objective lenses creates a tunnel vision, and a visibly narrow field of view.The Bushnell is shorter in length and has larger diameter lenses, and does not have a tunnel vision issue at all.The led is at the 9 o clock position and creates a bit of an obstruction in the field of view. TRS has it at 5 o clock.The glass quality is good, but I think the TRS has smoother glass. TRS red dot is also brighter.I also found a shift in the dot (parallax) when I viewed the dot from the 3 o clock edge of the lens.PROS: great price (Under $30), bright led, light weight. Comes with a good quality riser, battery, allen wrench and lens cloth.CONS: Narrow field of view, tunnel vision. Riser does not co witness with magpul, parallax in lens at 3 o clock (could be because of lens distortion in my item)All in all, I think it is a good red dot for what you pay, but I will not keep it. I will spend 20 bucks more and get another Bushnell. Yes, I know Bushnell QC can be an issue at times, and I have experienced an issue with the brightness of the red dot.