International Concepts 21-Inch Tea Table, Unfinished

I got this for a special purpose at church. It's the perfect size, and well manufactured. Screw holes and bores for hardware are precisely placed and it was easy to assemble. Initially I thought that the holes were too shallow, but I discovered that there was a tiny bit of sawdust in the bottom of some of them. Once I blew that out everything fit perfectly.The bottom of the tabletop is stamped "Mase in Vietnam". The description doesn't say this (I think). I might have been put off buying it if that was disclosed, as I prefer to minimize transportation energy use by buying local as much as possible. But then I would have missed out on this great product.I wish I knew what kind of wood was used - it's a light-colored hardwood of some sort, perhaps Acacia. It sometimes makes a difference when choosing stains and finishes. I'm hoping I can just test colors and finishes on the bottom of the tabletop.

Solid hardwood, sturdy, easy to put together, great price. I would definitely buy from this company again.I noticed some people were complaining about one leg being shorter than the other. I noticed mine wobbled as well when I first put it together. I had considered putting some padding under one leg as others had mentioned. Then I was instructed by my dad, to slightly loosen all the legs. Then stand the table up on it’s legs, and while pressing down on the table, tighten each leg little by little, working around several times until the screws were all fully tightened. Worked like a charm. 😊I hate MDF, plywood, and particle board. Sometimes they cost as much as solid wood furniture. I refuse to pay the price they want for what I call temporary or disposable furniture, because they just don’t last. I would rather to without.This company on the other hand, is a winner. 😁

Good sturdy table and fairly easy to assemble. It was however missing a wooden disk used to cover screw hole. Only 3 sent when there should have been 4.

I needed a 21" end table. 24" is standard. This is the perfect size in all dimensions, perfect design (for my design scheme) AND I get to choose hiw dark I want to stain it -have not done that yet. Also, it is very easy to assemble.

Looked like this package came already repackaged. Holes for table top were cutout incorrectly. Returned

This is a beautiful, sturdy little table that I got for holding a gorgeous (but heavy) piece of granite that I use for an end table top. Lots of cute details in the curved legs and arched skirt (not sure if that's what the side pieces for the top are called). I have a small desk by this same company that I love, so I didn't hesitate to get this little side table. I used a low voc wipe on Arm-R-Coat (satin) by General Finishes to get an easy great blonde wood natural finish.

Parawood, aka rubberwood, comes from the rubber tree in Asia. It is an inexpensive hardwood used to make low end furniture. It has a tight grain so it doesn’t accept paint well and is resistant to attempts to apply stain. It is prone to rot in humid areas so it is not recommended for outdoor or bathroom use. The rubber tree is used to make latex so rubberwood is not recommended for those with latex allergies.

The table is very well made. I was surprised that it is so sturdy. It is made of solid wood, with a close grain. I used a pre-stain B4 I applied a dark cherry finish, and it came out very nice. I have only 2 minor complaints about the table.1) The table does have a slight wobble if you leave the bottom of the legs bare wood. I used some cushioned felt pads from the hardware store and now it is fine. I had planned to do that anyway, so no problem there.2) After assembly, I found that the tapered hole plugs (these are used to cover the recessed screw heads on 2 sides of the table) were too small for the hole and went all the way into the hole, beyond flush. This occurred on only one of the leg assemblies. The other side was fine. All the plugs seem to be the same so the problem must be the holes were drilled to the wrong diameter (too big). If I find a good way to fix this, I'll update my review. It's not that noticeable to someone casually looking, but I know it is wrong and needs to be fixed. Overall, I'm happy with the table.