3Pcs Decapping Pin Upgrade for Lee 90783/90292 Universal Decap Die

Fit and function is exactly as the Lee part. So far the first one I've installed works great and at about half the price of the original. I'll be buying these in the future for replacing broken pins.

Anyone who reloads a lot knows that the decapping pin will fail at some point. These seem to be higher quality than the ones that come with the reloading dies. So far, I'm still on the first one and have hit a couple Burdan primers without breakage.

Works for decapping cases. Not for neck sizing necked cases as it is straight sided. Great for pistol cartridges.

The media could not be loaded. Complete junk, they are too big from the factory, the coating on them mean you have to grind them down to get them to fit through a flash hole, they break or bend very easy. First 3 of them lasted less than 200 rounds total, the 4th has about 70 rounds on it and I haven't used the 5th or 6th yet but I doubt they will last longer than the others. For reference my original decapping pin that came with my hand depriming tool lasted well over 10,000 rounds before bending and snapping off. I will be asking for a complete refund for these junk replacements.1 week laterrrr the 4th decapping pin has survived a torturing 8,000+ rounds of random pistol range pickups. Everything from .32 cal to .45 acp and everything in between, there is a slight bend to it but that might have more to do with the way the Frankford Arsenal Universal Hand Depriming tool works than anything else. It's still dumb that I had to grind the finish off and hone the pin enough to fit in normal flash holes but if the next 2 survive this long than I guess it was worth it. 1 big note, DO NOT try to use this with small or undersized flash holes even after grinding and honing, I had to pull multiple Speer Sig357 off the pin with a pliers as they have an unusually small flash hole.

I haven't used it yet but it does fit

First, I'll say I was slightly disappointed that the tip got stuck in the first few cases testing these in a Frankford Arsenal hand deprimer. I then spun the pins in a drill against a piece of sandpaper using deprimed cases as a gauge to reduce the taper just enough until the cases didn't get stuck anymore. Now they work beautifully!I used to have trouble with Blazer brass not fully pushing the primers out and the anvil getting stuck on the pin. But now with these new pins every primer is being removed. I almost decided to stop processing Blazer brass because of the issue, but now my frustration is over.The stem measures .202 and they fit perfectly in the lee decapping die collet. So they must have addressed the issue I've read in a few other reviews.So even though I did have to rework the tips, I am giving these 5 stars for solving the Blazer brass issue.

Purchased these for replacement for my Lee 9mm decapping die. They work perfectly.

I ground the tapers off of mine and they are fine now. Was getting stuck in .223 and .308 cases.