MAGZO Backed Adhesive Foam Padding 1/2" Thick x 12" W x 59" L, Black Neoprene Sheets, Closed Cell Foam Sheet Roll

This worked perfectly for me. I had to replace the foam that surrounds the kick plate on my 77 project car. The kick plate has a vent and door on it to allow air in. The existing foam seal that goes around the vent door had dried up long ago. So when it rains, water flows down the cowl drains, it goes inside the fender well and leaks through the kick plat because of the dried up foam. I cut the new pieces out using a utility knife. Luckily 12 inches die was exactly the width I needed. I then applied it to the kick plate the sticky part adhered to the plastic just fine. I installed it, put in the screws then put a garden hose down the cowl. No water got inside. I can now move on to restoring the floor of the car, as I could not do it until the leaks were fixed. The foam does not absorb water. I bought the 59 inch length for additional use on the car. I did not however remember to measure the length prior to my first cut so could not state if it was accurate. I got the 1/4 depth, and it was accurate as well as the width at 12 inches. I had no issue peeling the backing, nor any issue of the adhesive coming off the foam.

Exactly what is listed, sticks well, easy to trim to correct size, well worth the cost, simple to use,good quality, and all in all a great product

I used this for a arm rest cover the adhesive backing isn’t strong enough to hold it down at all edges. Not as strong as sealing tape products. So I guess it depends on use. The top side has a nice feel to the material.

This was a direct replacement for the tread on a sea doo. Easy to cut, the adhesive is great too. I’ll definitely order more as soon as I have a need for it

I was sound dampening my car with as close to 100% coverage as I could. I started with some sound skins pro stuff that had some foam-like material on the backside of the rubber but I quickly ran out of that and couldn’t bring myself to spend another $430 on 60sq ft. I ended up stumbling across this one night after searching for something else and it gave me an idea. I ordered some significantly less expensive siless and Amazon basics sound dampening and when I installed it, I put this foam padding on top and now it’s exactly the same thing as what I spent $400 on.

I have used other neoprene foams on Amazon but they were way to soft and aquariums sunk right through, this stuff works perfect as aquarium self leveling mat

I ordered an adhesive back foam what I recieved was a very old piece of foam and the adhesive stucked to the backing. I requested support from the compamy but they never got back to me. Not a good thing when you are in the middle of a project and half way complete. I hate it when companies sell people things and don't have any custermer service. I had to go out and buy some contact cement. So much for buying an adhesive backed product and having to buy contact adhecive to get it to work. All they had to do was replace the defective product to a void this review, but no they just wanted to ignore the problem and hope it would go away. This way they can off load defective stuff over the intenet, and keep your money and have the consumer spend more time and money to get their product to work. I'm under the gun, and time was a factor, and I'm a little upset.

I tried this to reduce sliding of mattress in camper when we sit up to read. Didn't help at all. Not sure how it would work with any rugs.