CLZYLRS Resin Phone case Mold Compatible with iPhone 12 Mini,epoxy Resin Personalized Mobile Phone case DIY Silicone case Silicone Resin Mould(12 Mini)

The watch band mold is perfect. It was my first time trying this and it came out great. It comes with enough pieces for one band, but if you can find the metal pieces elsewhere you can use the mold repeatedly. I bought a S/M for a 38mm Apple Watch and it fit easily.Some tips because the instructions are vague:- Use the side of the mold where you can pour the resin over the tiny metal bars.-Pour the band section until filled, and wipe it clean on the edges so the band comes out neat. Fill the two holes up until it is the same height as the center rectangle. Wipe the rectangle clean.- Put something over it while it dries so dust does not accumulate. Occasionally for the first few hours, I would check on the band to wipe the edges that spilled over.- Maybe half way through the drying time, when it is soft but not liquid-like, gently pull out the three metal bars. I was worried they would be stuck if it dried completely.Once it’s dry:- Remove all the parts from the mold. You can use a sharp knife over a cutting board to cut the rough edges, if any.- The clasp: The small nib must be inserted after you have the bar through the first hole.- The links to the watch: Use the small tool with a tiny fork like end to push the clasps into the hole, one by one. This takes a second to get a hang of.The loop that holds the extra band part was scratchy against the wrist so I removed it.This band is a little wide for a thinner wrist, but is perfect for my brother. Hope this helped! ❤️

good quality mold makes it easy to decorate! the mold is thick so filling it to the top might make the curing process long for UV resin, epoxy may be a better choice for this mold

They sent me a mold with a 2-3 inch long DEEP gouge down it, it’s entirely unusable. 0/10 on this order, this product never should have been sent.

I didn’t like how it had a bow on the side - like bowed out so I had to fill it and then place it next to something in order to make sure it didn’t bow out as it was forming

The media could not be loaded. Me agrada que manejable pero está chueco

I love this mold. I have made 3 iPhone cases already. Best purchase ever. I can be as creative as I want.Definitely recommend it

A good mold with a perfect fit! I’ve made 2 cases for my phone so far and both fit well. Easy on easy off with amazing camera protection. Easy to pour and doesn’t take too much resin I think I used a total of 60 mls maybe. Can’t recall as both cases were made with left overs from another pour.

The mold is great. They do need to send better instructions as well as recommendations for the type of rubber epoxy. The epoxy rubber associated in the "Bought With" section is very flimsy and sticky. It should be a more firm silicone rubber. BUT after I got the bands made and went to apply them the pins they send for the watch adapters are too long. I tried each of the 3 sets that came with the mold and none of them fit. They did not fit the adapter to the watch nor the buckle.