120 Pcs Drawer Wedges with Screws, Drawer Bottom Support Brackets, Fixing Mending Wedges, Plastic Angle Code Bracket Fasteners, Drawer Reinforcement Repair Kit for Furniture Sagging Drawer

My IKEA drawers were busting at the middle…all 10 of them in two dressers. The tethers that extend across the drawers sold by others were pricey so I tried these. Simple, easy, flexible, and 100% effective. They look like the ones that are installed in the drawers from the store, except that you’re adding many more at the likely failure points. The only thing you have to watch for is angling the screw enough to catch the wood effectively and completely. Now I don’t have to keep my clothes ON my dresser because I dread another one collapsing and preventing that drawer and the one below it from opening and closing. Even Gorilla Glue didn’t hold the bottoms in place for more than a few months. I wish I had found these two years ago!

I bought these to reinforce the drawers in a small IKEA drawer unit. The unit is the perfect size for my fountain pen ink, but putting so many mostly-glass ink bottles into the drawers would surely lead to bowing and separation of the drawer bottoms from the drawer frames. I looked into a lot of ways to reinforce the drawers including mounting steel rods to the bottoms, and everything seemed so involved and expensive. Then I found these. They slide into the lip between the drawer bottom and frame and provide just enough strength to keep the drawer square and the base in place. The drawers do sag in the very middle, I'm not gonna lie, but not NEARLY as much as an un-reinforced drawer. Screwing them in place was easy, and there are plenty of wedges in the package.

So our drawers started sagging in the middle. This was the perfect fix. Some drawers I just had to use 2 and some 4 but it did the trick. Easy to install.iused a drill for faster fix

From all the the reviews I read about the "IKEA Alex" drawer furniture, the number one complaint is bottom drawer sag over time due to the bottoms being so thin. I installed these wedges as a "preventative upgrade", so hopefully it will help mitigate this issue. Do yourself a favor and pre-drill the holes before installing the screws if installing on the IKEA Alex drawers. The drawers are made from particle board and MDF, so pre-drilling will prevent the drawer frame from cracking. Also, do not over tighten. I personally put the screws in by hand after pre-drilling so the particle board wouldn't crack.

Worked as described but it is cheap plastic so it won’t support much weight.

Every piece accounted for and they all worked.

Easy to install. Be careful screwing too much because it will go through the opposite end but so far so good.

The bottom of several of my kitchen drawers were falling out. I had to glue and put them together with clamps while I was working on them. I bought these in conjunctions with heavier metal supports that extended across the bottom of the drawer. These work great. They support the drawer well. They give extra support where the metal brackets are not fitted. I like them so much thatI have been putting them on all my drawers around the house. These should keep them from falling apart one day.