Replacement Lever Basin Tap Conversion Kit Reviver 1/2" 1/4 Turn Pair Metal Head

When my taps in the kitchen started to leak I spent about 3 weeks trying to find the right quarter turn valve to replace the leaking one. I spent may trips to my local DIY to find a replacement. However after no luck I just went and ordered this. I though that based on the low price that it would be cheap feeling and would look out of place. However, I am pleased to report that the taps are of good quality and were easy to fit to my existing taps. If I have this issue again then I will be buying another set of these.

These taps are easy to install. Levers are a decent size not too long. Best point is the tap stops at 90 degrees so no chance of moving past this point.Had these installed for two weeks and so far so good.

Fitted my basin taps in the bathroom, but a bit big for what appeared to be the same taps in the cloakroom! Lovely to be able to turn the taps on so easily when my fingers are sore.

This a very well made product sold to fit all sinks with 1/2 turn taps. Not true, it was unable to connect to the tap at all being too big. So a waste of money. Buyer beware.

Bought a pair a while back as the traditional washer ones on bathroom washbasin the brass dried up and became very stiff so while had water turned off for something else did these too. Really easy they, fitted fine so no washer packing needed like some other people found. Wish I'd fitted when I received themI have just ordered some more for downstairs washroom and another basin. I also ordered some to take to my son's where the grandkids struggle to work the taps, so that should sort for them too. Solid look and feel, at the price much cheaper (half the price) than replacement ceramic replacements I had to buy to fix the kitchen taps dripping, and you get the two solid lever tops too !

I'd replaced my tap to levers about 8 years ago and started to get a leak from the Swan neck and one tap started squeaking so got these. Fitted quickly and even the leak stopped, which I hadn't expected.

Splines did not engage with each other and tap just flopped around. Full refund given but a bit of a waste of time fitting and then swapping for some decent ones.

They look good, and did the job. levers are slightly shorter than the previous ones, but the tops are shiny, and the whole repalcementof the fitting did not take long, and seem to work well.